ak4366 AKM Semiconductor, Inc., ak4366 Datasheet - Page 17

• Manufacturer Part Number: ak4366
• Description: Low Power 24-bit 2ch Dac With Hp-amp
• Manufacturer: AKM Semiconductor, Inc.

ASAHI KASEI
The AK4366 includes a digital de-emphasis filter (tc = 50/15µs) by IIR filter corresponding to three sampling frequencies
(32kHz, 44.1kHz and 48kHz). In serial mode (P/S pin = “L”), the de-emphasis filter is enabled by setting DEM1-0 bits
(Table 7).
In parallel mode (P/S pin = “H”), the de-emphasis filter corresponding to 44.1kHz is enabled by setting DEM pin “H”
(Table 8).
In serial mode (P/S pin = “L”), the low frequency boost signal can be output from DAC by controlling BST1-0 bits (Table
9). The setting value is common in Lch and Rch.
The AK4366 should be reset once by bringing PDN “L” upon power-up.
In serial mode (P/S pin = “L”), after exiting reset, VCOM, DAC, HPL and HPR switch to the power-down state. The
contents of the control register are maintained until the reset is done. DAC exits reset and power down state by MCLK
after PMDAC bit is changed to “1”, and then DAC is powered up and the internal timing starts clocking by LRCK “↑”.
DAC is in power-down mode until MCLK and LRCK are input.
In parallel mode (P/S pin = “H”), VCOM and DAC are powered up by PDN pin “H”. Headphone amp is powered up by
MUTEN pin “H”. DAC exits reset and power down state by MCLK after PDN pin goes to “H”, and then DAC is powered
up and the internal timing starts clocking by LRCK “↑”. DAC is in power-down mode until MCLK and LRCK are input.
MS0248-E-01
De-emphasis Filter
Bass Boost Function
System Reset
Table 8. De-emphasis Filter Frequency Select (Parallel Mode)
Table 7. De-emphasis Filter Frequency Select (Serial Mode)
DEM1 bit
BST1 bit
0
0
1
1
0
0
1
1
Table 9. Low Frequency Boost Select
DEM pin
DEM0 bit
BST0 bit
H
L
0
1
0
1
0
1
0
1
- 17 -
De-emphasis
44.1kHz
De-emphasis
OFF
44.1kHz
BOOST
48kHz
32kHz
MAX
MIN
MID
OFF
OFF
Default
Default
[AK4366]
2004/03