cx82100 Conexant Systems, Inc., cx82100 Datasheet - Page 152

• Manufacturer Part Number: cx82100
• Description: Home Network Processor Hnp
• Manufacturer: Conexant Systems, Inc.

8.8.8
8-18
Bit(s)
27:16
31
30
29
28
15
14
13
Type
RW
RW
RW
RW
RW
RW
RW
RW
USB Control Register 1 (U_CTR1: 0x0033002C)
Default
13'b0
1'b0
1'b1
1'b0
1’b0
1'b0
1'b0
1'b0
Conexant Proprietary and Confidential Information
USB_IE
USB_RESET
AI_RESUME
RV_INIT
EP3_IN_DMA_RESET
EP2_IN_DMA_RESET
EP1_IN_DMA_RESET
CX82100 Home Network Processor Data Sheet
Name
Global USB Interrupt Enable.
USB Reset.
Writing a 1 will reset the entire USB device (including the UDC
Core) to default state. Software must clear this bit by writing a 0 or
reading it. This bit self-clears after being read.
Application Initiated Resume.
This is an application initiated Resume signal. Writing a 1 to this bit
will resume the USB bus from the Suspended Mode. The peripheral
must assert the Dev_Resume signal to the UDC Core for one 12
MHz clock period. Setting this bit is meaningful only when the USB
bus is in the Suspended mode.
In response to this signal, the UDC will deassert the UDC_Suspend
signal, drive the non-IDLE (K State) onto the USB Cable for 12 ms,
and perform the Remote Wakeup Operation. When the
UDC_Suspend signal is deasserted in response to the assertion of
the Dev_Resume signal, the peripheral must restart the clock (to
the UDC Core) as soon as possible in order for the Core to start the
counters for counting the Wakeup sequence time.
This bit self-clears one cycle after it is been set.
Buffer Pointer Initialized Flag.
Set by firmware before activating OUT Endpoints, but after writing
the pointer to the circular RX DMA buffer. Must be reset by firmware
at the next instruction.
Reserved. Should be written to all 0s.
Endpoint 3 IN DMA Channel Reset.
Writing a 1 to this bit resets the DMA channel associated with the
EP3_IN endpoint. Must be reset to a 0 by firmware and can be done
immediately after setting to a 1.
Endpoint 2 IN DMA Channel Reset.
Writing a 1 to this bit resets the DMA channel associated with the
EP2_IN endpoint. Must be reset to a 0 by firmware and can be done
immediately after setting to a 1.
Endpoint 1 IN DMA Channel Reset.
Writing a 1 to this bit resets the DMA channel associated with the
EP1_IN endpoint. Must be reset to a 0 by firmware and can be done
immediately after setting to a 1.
0 = Disable all USB related interrupts.
1 = Enable all USB related interrupts enabled. Each individual
interrupt can be further controlled by its corresponding
interrupt enable bit.
Description
101306C