SAA7113 Philips Semiconductors, SAA7113 Datasheet - Page 34

• Manufacturer Part Number: SAA7113
• Description: 9-bit video input processor
• Manufacturer: Philips Semiconductors

Philips Semiconductors
8.11
The real-time control and status output signal contains
serial information about the actual system clock
(increment of the HPLL), subcarrier frequency, increment
and phase (via reset) of the FSC-PLL and PAL sequence
bit. The signal can be used for various applications in
external circuits, e.g. in a digital encoder to achieve clean
encoding. The SAA7113H supports RTC level 3.1 (see
external document “RTC Functional Description” ,
available on request).
8.12
These two pins are multi functional inputs/output
controlled by I
RTSE13 to RTSE10, located in subaddress 12H;
see Tables 49 and 50.
The RTS0 terminal can be strapped to ground via a 3.3 k
resistor to change the I
4AH/4BH to 48H/49H (the strapping information is read
only during the reset sequence).
The RTS1 terminal can be configured as Data Output to
3-state (DOT) input by RTSE13 to RTSE10 = 0000 to
control the VPO port (bits 7 to 0) via hardware according
to Table 19.
Table 20 BST instructions supported by the SAA7113H
1999 Jul 01
INSTRUCTION
9-bit video input processor
SAMPLE
BYPASS
EXTEST
IDCODE
INTEST
CLAMP
USER1
RTCO output
RTS0, RTS1 terminals
2
C-bus bits RTSE03 to RTSE00 and
This mandatory instruction provides a minimum length serial path (1 bit) between TDI and TDO
when no test operation of the component is required.
This mandatory instruction allows testing of off-chip circuitry and board level interconnections.
This mandatory instruction can be used to take a sample of the inputs during normal operation of
the component. It can also be used to preload data values into the latched outputs of the
boundary scan register.
This optional instruction is useful for testing when not all ICs have BST. This instruction addresses
the bypass register while the boundary scan register is in external test mode.
This optional instruction will provide information on the components manufacturer, part number and
version number.
This optional instruction allows testing of the internal logic (no support for customers available).
This private instruction allows testing by the manufacturer (no support for customers available).
2
C-bus slave address from default
34
DESCRIPTION
Table 19 Digital output control via RTS1 (enabled by bits
9
The SAA7113H has built in logic and 5 dedicated pins to
support boundary scan testing which allows board testing
without special hardware (nails). The SAA7113H follows
the “IEEE Std. 1149.1 - Standard Test Access Port and
Boundary-Scan Architecture” set by the Joint Test Action
Group (JTAG) chaired by Philips.
The 5 special pins are Test Mode Select (TMS), Test
Clock (TCK), Test Reset (TRST), Test Data Input (TDI)
and Test Data Output (TDO).
The BST functions BYPASS, EXTEST, INTEST,
SAMPLE, CLAMP and IDCODE are all supported
(see Table 20). Details about the JTAG BST-TEST can be
found in the specification “ IEEE Std. 1149.1” . A file
containing the detailed Boundary Scan Description
Language (BSDL) description of the SAA7113H is
available on request.
BOUNDARY SCAN TEST
OEYC
0
1
0
1
RTSE13 to RTSE10 = 0)
(RTS1)
DOT
0
0
1
1
Product specification
VPO7 TO VPO0
SAA7113H
active
Z
Z
Z