HD6417729 HITACHI [Hitachi Semiconductor], HD6417729 Datasheet - Page 230

• Manufacturer Part Number: HD6417729
• Description: Hitachi Microcomputer Development Environment System
• Manufacturer: HITACHI [Hitachi Semiconductor]

6.5.7
1. When MMU settings are modified or when a user program is changed after GO command
2. When a completion-type exception occurs during exception branch acquisition, the next
6.5.8
1. When [Go to cursor], [Step In], [Step Over], or [Step Out] is selected, the settings of Break
2. Setting of Break Condition 2 is disabled when an instruction to which a BREAKPOINT has
3. If a PC break address condition is set to the slot instruction after a delayed branch instruction,
4. When a Break Condition is satisfied, emulation may stop after two or more instructions have
5. Note on DSP repeat loop:
Rev. 2.0, 01/01, page 206 of 216
completion before trace display, the displayed mnemonics or operand may not be correct.
address to the address in which an exception occurs is acquired.
Condition 2 are disabled.
been set is executed. Accordingly, do not set a BREAKPOINT to an instruction in which
Break Condition 2 is satisfied.
user program execution cannot be terminated before the slot instruction execution even when
the PC option is specified in the <addrcycle> parameter; execution stops before the branch
destination instruction.
been executed.
A breakpoint is equal to a branch instruction. In some DSP repeat loops, branch instructions
cannot be set. For these cases, do not set breakpoints. Refer to the hardware manual for
details.
Notes on Setting the [Trace] Window
Notes on Setting the BREAKCONDITION_SET Command