HD6417729 HITACHI [Hitachi Semiconductor], HD6417729 Datasheet - Page 231

• Manufacturer Part Number: HD6417729
• Description: Hitachi Microcomputer Development Environment System
• Manufacturer: HITACHI [Hitachi Semiconductor]

6.5.9
In the [Configuration] window, if [User] is set while the UBC_MODE command has been set, the
STEP-type commands that use BREAK_CONDITION2 for implementation cannot be used. If
these commands are used, the message box shown in figure 6.12 is displayed.
Note: Note the followings when the UBC is used in the user program:
6.5.10
1. Moving Source File Position after Creating Load Module
2. Source-level Execution
When the source file is moved after creating the load module, the [Open] dialog box may be
displayed to specify the source file during the debugging of the created load module. Select
the corresponding source file and click the [Open] button.
Source file
Do not display source files that do not correspond to the load module in the program
window. For a file having the same name as the source file that corresponds to the load
module, addresses are displayed in the program window but operation in the window may
not work properly.
Step
Even standard C libraries are executed. To return to a higher-level function, enter Step
Out. In a for statement or a while statement, executing a single step does not move
execution to the next line. To move to the next line, execute two steps.
Notes on HDI
Notes on Setting the UBC_MODE Command
When the E10A emulator is connected:
When the ASEMD0 pin is low without connecting the E10A emulator:
When the ASEMD0 pin is high without connecting the E10A emulator:
Always write 1 to bit 2 in the BRCR register.
Always write 1 to bit 2 in the BRCR register.
Always write 0 to bit 2 in the BRCR register.
Figure 6.12 [HDI] Message Box
Rev. 2.0, 01/01, page 207 of 216