ATMEGA163 ATMEL [ATMEL Corporation], ATMEGA163 Datasheet - Page 83
ATMEGA163
Manufacturer Part Number
ATMEGA163
Description
8-bit Microcontroller with 16K Bytes In-System Programmable Flash
Manufacturer
ATMEL [ATMEL Corporation]
Datasheet
1.ATMEGA163.pdf
(187 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
ATMEGA163-8AC
Manufacturer:
ATMEL
Quantity:
1 600
Part Number:
ATMEGA163-8AI
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
Company:
Part Number:
ATMEGA163L-4AI
Manufacturer:
ATMEL
Quantity:
984
- Current page: 83 of 187
- Download datasheet (3Mb)
ATmega163(L)
• Bit 6 – TWEA: Two-wire Serial Interface Enable Acknowledge Flag
TWEA Flag controls the generation of the acknowledge pulse. If the TWEA bit is set,
the ACK pulse is generated on the Two-wire Serial Bus if the following conditions are
met:
1. The device’s own slave address has been received.
2. A general call has been received, while the TWGCE bit in the TWAR is set.
3. A data byte has been received in Master Receiver or Slave Receiver mode.
By setting the TWEA bit low, the device can be virtually disconnected from the Two-wire
Serial Bus temporarily. Address recognition can then be resumed by setting the TWEA
bit again.
• Bit 5 – TWSTA: Two-wire Serial Bus START Condition Flag
The TWSTA Flag is set by the application when it desires to become a Master on the
Two-wire Serial Bus. The Two-wire Serial Interface hardware checks if the bus is avail-
able, and generates a START condition on the bus if it is free. However, if the bus is not
free, the Two-wire Serial Interface waits until a STOP condition is detected, and then
generates a new START condition to claim the bus Master status.
• Bit 4 – TWSTO: Two-wire Serial Bus STOP Condition Flag
TWSTO is a Stop Condition Flag. In Master mode setting the TWSTO bit in the Control
Register will generate a STOP condition on the Two-wire Serial Bus. When the STOP
condition is executed on the bus, the TWSTO bit is cleared automatically. In Slave mode
setting the TWSTO bit can be used to recover from an error condition. No stop condition
is generated on the bus then, but the Two-wire Serial Interface returns to a well-defined
unaddressed Slave mode and releases the SCL and SDA lines to a high impedance
state.
• Bit 3 – TWWC: Two-wire Serial Bus Write Collision Flag
The TWWC bit is set when attempting to write to the Two-wire Serial Interface Data
Register – TWDR when TWINT is low. This flag is cleared by writing the TWDR Register
when TWINT is high.
• Bit 2 – TWEN: Two-wire Serial Interface Enable Bit
The TWEN bit enables Two-wire Serial Interface operation. If this bit is cleared (zero),
the bus outputs SDA and SCL are set to high impedance state, and the input signals are
ignored. The interface is activated by setting this bit (one).
• Bit 1 – Res: Reserved Bit
This bit is a reserved bit in the ATmega163 and will always read as zero.
83
1142E–AVR–02/03
Related parts for ATMEGA163
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Atmel CryptoMemory
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
Atmel CryptoMemory
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
Atmel CryptoMemory, 16Kbit
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
8-bit Atmel Microcontrollers
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
8-bit Atmel Microcontroller with 64K/128K/256K Bytes In-System Programmable Flash
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
8-bit Atmel Microcontroller with 16/32/64/128K Bytes In-System Programmable Flash
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
8-bit Atmel Microcontroller with 16/32/64K Bytes In-System Programmable Programmable
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
INTERVAL AND WIPE/WASH WIPER CONTROL IC WITH DELAY
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Low-Voltage Voice-Switched IC for Hands-Free Operation
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
MONOLITHIC INTEGRATED FEATUREPHONE CIRCUIT
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
AM-FM Receiver IC U4255BM-M
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Monolithic Integrated Feature Phone Circuit
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Multistandard Video-IF and Quasi Parallel Sound Processing
Manufacturer:
ATMEL Corporation
Datasheet: