LPC2109FBD64/01 NXP [NXP Semiconductors], LPC2109FBD64/01 Datasheet - Page 19

• Manufacturer Part Number: LPC2109FBD64/01
• Description: Single-chip 16/32-bit microcontrollers; 64/128/256 kB ISP/IAP flash with 10-bit ADC and CAN
• Manufacturer: NXP [NXP Semiconductors]

NXP Semiconductors
Product data sheet
LPC2109_2119_2129_6
6.16.1 Features
6.16 Real-time clock
6.17 Pulse width modulator
The RTC is designed to provide a set of counters to measure time when normal or idle
operating mode is selected. The RTC has been designed to use little power, making it
suitable for battery powered systems where the CPU is not running continuously (Idle
mode).
The PWM is based on the standard Timer block and inherits all of its features, although
only the PWM function is pinned out on the LPC2109/2119/2129. The Timer is designed
to count cycles of the peripheral clock (PCLK) and optionally generate interrupts or
perform other actions when specified timer values occur, based on seven match registers.
The PWM function is also based on match register events.
The ability to separately control rising and falling edge locations allows the PWM to be
used for more applications. For instance, multi-phase motor control typically requires three
non-overlapping PWM outputs with individual control of all three pulse widths and
positions.
Two match registers can be used to provide a single edge controlled PWM output. One
match register (MR0) controls the PWM cycle rate, by resetting the count upon match.
The other match register controls the PWM edge position. Additional single edge
controlled PWM outputs require only one match register each, since the repetition rate is
the same for all PWM outputs. Multiple single edge controlled PWM outputs will all have a
rising edge at the beginning of each PWM cycle, when an MR0 match occurs.
•
•
•
•
•
•
•
•
•
Enabled by software but requires a hardware reset or a watchdog reset/interrupt to be
disabled.
Incorrect/incomplete feed sequence causes reset/interrupt if enabled.
Flag to indicate watchdog reset.
Programmable 32-bit timer with internal pre-scaler.
Selectable time period from (T
T
Measures the passage of time to maintain a calendar and clock.
Ultra low power design to support battery powered systems.
Provides Seconds, Minutes, Hours, Day of Month, Month, Year, Day of Week, and Day
of Year.
Programmable reference clock divider allows adjustment of the RTC to match various
crystal frequencies.
cy(PCLK)
4.
Rev. 06 — 10 December 2007
cy(PCLK)
256
LPC2109/2119/2129
Single-chip 16/32-bit microcontrollers
4) to (T
cy(PCLK)
2
32
© NXP B.V. 2007. All rights reserved.
4) in multiples of
19 of 44