ATA5771_09 ATMEL [ATMEL Corporation], ATA5771_09 Datasheet - Page 45
ATA5771_09
Manufacturer Part Number
ATA5771_09
Description
Microcontroller with UHF ASK/FSK Transmitter
Manufacturer
ATMEL [ATMEL Corporation]
Datasheet
1.ATA5771_09.pdf
(287 pages)
- Current page: 45 of 287
- Download datasheet (5Mb)
4.3
4.3.1
4.3.2
4511I–RKE–02/07
CLK Output
Clock Pulse Take-over
Output Matching and Power Setting
Figure 4-1.
Using C
tances on each side of the crystal of C
crystal of C
typical with worst case tolerances of ±16.3 kHz to ±28.8 kHz results.
An output CLK signal is provided for a connected microcontroller, the delivered signal is CMOS
compatible if the load capacitance is lower than 10 pF.
The clock of the crystal oscillator can be used for clocking the microcontroller. Atmel
ATARx9x has the special feature of starting with an integrated RC-oscillator to switch on the
T5754 with ENABLE = H, and after 1 ms to assume the clock signal of the transmission IC, so
that the message can be sent with crystal accuracy.
The output power is set by the load impedance of the antenna. The maximum output power is
achieved with a load impedance of Z
to V
The delivered current pulse of the power amplifier is 9 mA and the maximum output power is
delivered to a resistive load of 465 if the 1.0 pF output capacitance of the power amplifier is
compensated by the load impedance.
An optimum load impedance of:
Z
7.5 dBm.
The load impedance is defined as the impedance seen from the T5754’s ANT1, ANT2 into the
matching network. Do not confuse this large signal load impedance with a small signal input
impedance delivered as input characteristic of RF amplifiers and measured from the application
into the IC instead of from the IC into the application for a power amplifier.
Less output power is achieved by lowering the real parallel part of 465 where the parallel imag-
inary part should be kept constant.
Output power measurement can be done with the circuit of
component values must be changed to compensate the individual board parasitics until the
T5754 has the right load impedance Z
used to measure the output power must be calibrated out.
Load
S
= 465 || j/(2
to deliver the DC current.
4
= 9.2 pF ±2%, C
0
= 3.2 pF ±10% and a crystal with C
Tolerances of Frequency Modulation
XTAL
V
S
1.0 pF) = (166 + j223) thus results for the maximum output power of
5
= 6.8 pF ±5%, a switch port with C
C
Stray1
Crystal equivalent circuit
Load,opt
C
Stray1
M
Load,opt
= (166 + j223) . There must be a low resistive path
L
= C
C
M
0
= (166 + j223) . Also the damping of the cable
Stray2
M
R
= 13 fF ±10%, an FSK deviation of ±21 kHz
S
= 1 pF ±10%, a parallel capacitance of the
Figure 4-2 on page
C
Switch
Stray2
C
5
= 3 pF ±10%, stray capaci-
C
Switch
C
4
6. Note that the
T5754
®
’s
5
Related parts for ATA5771_09
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Atmel CryptoMemory
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
Atmel CryptoMemory
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
Atmel CryptoMemory, 16Kbit
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
8-bit Atmel Microcontrollers
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
8-bit Atmel Microcontroller with 64K/128K/256K Bytes In-System Programmable Flash
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
8-bit Atmel Microcontroller with 16/32/64/128K Bytes In-System Programmable Flash
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
INTERVAL AND WIPE/WASH WIPER CONTROL IC WITH DELAY
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Low-Voltage Voice-Switched IC for Hands-Free Operation
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
MONOLITHIC INTEGRATED FEATUREPHONE CIRCUIT
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
AM-FM Receiver IC U4255BM-M
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Monolithic Integrated Feature Phone Circuit
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Multistandard Video-IF and Quasi Parallel Sound Processing
Manufacturer:
ATMEL Corporation
Datasheet: