AK4343EN AKM [Asahi Kasei Microsystems], AK4343EN Datasheet - Page 41

• Manufacturer Part Number: AK4343EN
• Description: Stereo DAC with HP/RCV/SPK-AMP
• Manufacturer: AKM [Asahi Kasei Microsystems]

ASAHI KASEI
2. ALC Recovery Operation
The ALC recovery operation waits for the WTM2-0 bits (Table 27) to be set after completing the ALC limiter operation.
If the input signal does not exceed “ALC recovery waiting counter reset level” (Table 24) during the wait time, the ALC
recovery operation is done. The AVL and AVR values are automatically incremented by RGAIN1-0 bits (Table 28) up to
the set reference level (Table 29) with zero crossing detection which timeout period is set by ZTM1-0 bits (Table 26).
Then the AVL and AVR are set to the same value for both channels. The ALC recovery operation is done at a period set
by WTM2-0 bits. When zero cross is detected at both channels during the wait period set by WTM2-0 bits, the ALC
recovery operation waits until WTM2-0 period and the next recovery operation is done. If ZTM1-0 is longer than
WTM2-0 and no zero crossing occurs, the ALC recovery operation is done at a period set by ZTM1-0 bits.
For example, when the current AVOL value is 30H and RGAIN1-0 bits are set to “01”, AVOL is changed to 32H by the
auto limiter operation and then the input signal level is gained by 0.75dB (=0.375dB x 2). When the AVOL value exceeds
the reference level (REF7-0), the AVOL values are not increased.
When
during the ALC recovery operation, the waiting timer of ALC recovery operation is reset. When
the waiting timer of ALC recovery operation starts.
The ALC operation corresponds to the impulse noise. When the impulse noise is input, the ALC recovery operation
becomes faster than a normal recovery operation (Fast Recovery Operation). When large noise is input to microphone
instantaneously, the quality of small level in the large noise can be improved by this fast recovery operation. The speed of
fast recovery operation is set by RFST1-0 bits (Table 30).
MS0478-E-01
“ALC recovery waiting counter reset level (LMTH1-0) ≤ Output Signal < ALC limiter detection level (LMTH1-0)”
“ALC recovery waiting counter reset level (LMTH1-0) > Output Signal”,
WTM2
0
0
0
0
1
1
1
1
WTM1
0
0
1
1
0
0
1
1
RGAIN1
WTM0
0
0
1
1
Table 27. ALC Recovery Operation Waiting Period
0
1
0
1
0
1
0
1
Table 28. ALC Recovery GAIN Step
RGAIN0
16384/fs
1024/fs
2048/fs
4096/fs
8192/fs
128/fs
256/fs
512/fs
0
1
0
1
- 41 -
1 step
2 step
3 step
4 step
ALC Recovery Operation Waiting Period
1024ms
2048ms
128ms
256ms
512ms
8kHz
16ms
32ms
64ms
GAIN STEP
0.375dB
0.750dB
1.125dB
1.500dB
1024ms
16kHz
128ms
256ms
512ms
16ms
32ms
64ms
8ms
Default
44.1kHz
185.8ms
371.5ms
11.6ms
23.2ms
46.4ms
92.9ms
5.8ms
2.9ms
Default
[AK4343]
2006/10