HD6413308 Hitachi Semiconductor, HD6413308 Datasheet - Page 146

• Manufacturer Part Number: HD6413308
• Description: Hitachi Single-Chip MicroComputer
• Manufacturer: Hitachi Semiconductor

Bit 1
OVIE
Bit 0 – Reserved: This bit cannot be modified and is always read as “1.”
6.2.5 Timer Control/Status Register (TCSR) – H’FF91
Bit
Initial value
Read/Write
The TCSR is an 8-bit readable and partially writable* register contains the seven interrupt flags and
specifies whether to clear the counter on compare-match A (when the FRC and OCRA values
match).
* Software can write a “0” in bits 7 to 1 to clear the flags, but cannot write a “1” in these bits.
The TCSR is initialized to H’00 at a reset and in the standby modes.
Bit 7 – Input Capture Flag A (ICFA): This status bit is set to “1” to flag an input capture A
event. If BUFEA = “0,” ICFA indicates that the FRC value has been copied to ICRA. If BUFEA =
“1,” ICFA indicates that the old ICRA value has been moved into ICRC and the new FRC value
has been copied to ICRA.
ICFA must be cleared by software. It is set by hardware, however, and cannot be set by software.
Bit 7
ICFA
0
1
0
1
Description
Timer overflow interrupt request (FOVI) is disabled.
Timer overflow interrupt request (FOVI) is enabled.
Description
To clear ICFA, the CPU must read ICFA after it
has been set to "1," then write a “0” in this bit.
This bit is set to 1 when an FTIA input signal causes the FRC
value to be copied to ICRA.
R/(W)* R/(W)* R/(W)* R/(W)* R/(W)* R/(W)* R/(W)*
ICFA
7
0
ICFB
6
0
ICFC
5
0
ICFD
131
4
0
OCFA
3
0
OCFB
2
0
OVF
1
0
(Initial value)
(Initial value)
CCLRA
R/W
0
0