HD6433044 Hitachi Semiconductor, HD6433044 Datasheet - Page 160

• Manufacturer Part Number: HD6433044
• Description: (HD64 Series) Hitachi Single-Chip Microcomputer
• Manufacturer: Hitachi Semiconductor

6.4.3
After driving the BREQ pin low, hold it low until BACK goes low. If BREQ returns to the high
level before BACK goes low, the bus arbiter may operate incorrectly.
To terminate the external-bus-released state, hold the BREQ signal high for at least three states.
If BREQ is high for too short an interval, the bus arbiter may operate incorrectly.
6.4.4 Transition To Software Standby Mode
If contention occurs between a transition to software standby mode and a bus request from an
external bus master, the bus may be released for one state just before the transition to software
standby mode (see figure 6-23). When using software standby mode, clear the BRLE bit to 0 in
BRCR before executing the SLEEP instruction.
ø
BREQ
BACK
Address bus
Strobe
Figure 6-23 Contention between Bus-Released State and Software Standby Mode
BREQ Input Timing
Bus-released state
146
Software standby mode