6P30006ANLGI8 IDT, 6P30006ANLGI8 Datasheet
6P30006ANLGI8
Specifications of 6P30006ANLGI8
Related parts for 6P30006ANLGI8
6P30006ANLGI8 Summary of contents
Page 1
... CLOCK DISTRIBUTION CIRCUIT Description The IDT6P30006A is a low-power, eight output clock distribution circuit. The device takes a TCXO or LVCMOS input and generates eight high-quality outputs. It includes a redundant input with automatic glitch-free switching when the primary reference is removed. The primary input may be selected by the user by pulling the SEL pin low or high ...
Page 2
... Buffered output. Outputs tri-state with weak pull-down when disabled. Output enable control for OUT3. Internal pull-up resistor. See table above. Connect to 13 MHz LVCMOS clock input. See table above. Connect to +1.8 V. Connect to ground. 2 DISTRIBUTION CIRCUITS Primary Input LVCMOS_INB TCXO_INA OUTx Disabled Enabled IDT6P30006A REV D 061711 ...
Page 3
... Buffered output. Outputs tri-state with weak pull-down when disabled. Buffered output. Outputs tri-state with weak pull-down when disabled. Buffered output. Outputs tri-state with weak pull-down when disabled. Connect to +1.8 V. Connect to ground. Connect to 13 MHz TCXO input. Connect to +1 DISTRIBUTION CIRCUITS IDT6P30006A REV D 061711 ...
Page 4
... Controller (host) sends the data byte count = X • IDT clock will acknowledge • Controller (host) starts sending Byte N through Byte (see Note 2) • IDT clock will acknowledge each byte one at a time • Controller (host) sends a Stop bit Index Block Write Operation Controller (Host) IDT (Slave/Receiver) T ...
Page 5
... IDT6P30006A CLOCK DISTRIBUTION CIRCUIT Address The IDT6P30006A is a slave-only device that supports block read and block write protocol using a single 7 bit address and read/write bit. A block write (D2 ( applications where the indexed block write and block read are used, the dummy byte (bit 11-18) functions as a register-offset (8 bits) pointer ...
Page 6
... Power Up Output(s) Affected RW 0 Not applicable RW 0 Not applicable RW 0 Not applicable RW 0 Not applicable RW 0 Not applicable RW 0 Not applicable RW 0 Not applicable RW 1 Not applicable 6 DISTRIBUTION CIRCUITS Notes Not applicable Notes Not applicable Notes Notes Notes IDT6P30006A REV D 061711 ...
Page 7
... Other signal traces should be routed away from the IDT6P30006A.This includes signal traces just underneath the device layers adjacent to the ground plane layer used by the device. ...
Page 8
... Stresses above the ratings listed below can cause permanent damage to the IDT6P30006A. These ratings, which are standard values for IDT commercially rated parts, are stress ratings only. Functional operation of the device at these or any other conditions above those indicated in the operational sections of the specifications is not implied. ...
Page 9
... Symbol Conditions θ Still air JA θ 1 m/s air flow JA θ 2.5 m/s air flow JA θ DISTRIBUTION CIRCUITS Min. Typ. Max. 12.6 13 13.4 ±100 ±900 0 1 Min. Typ. Max. Units ° C/W 29.1 ° C/W 22.8 ° C/W 21.0 ° C/W 41.8 IDT6P30006A REV D 061711 Units MHz mV MHz µs ppm ...
Page 10
... RoHS compliant package. 5. “I” at the end of part number indicates industrial temperature range. 6. Bottom marking: country of origin if not USA. IDT® CLOCK DISTRIBUTION CIRCUIT 10 DISTRIBUTION CIRCUITS IDT6P30006A REV D 061711 ...
Page 11
... Marking 6P30006ANLGI see pg. 10 6P30006ANLGI8 “G” after the two-letter package code are the Pb-Free configuration and are RoHS compliant. While the information presented herein has been checked for both accuracy and reliability, Integrated Device Technology (IDT) assumes no responsibility for either its use or for the infringement of any patents or other rights of third parties, which would result from its use. No other circuits, patents, or licenses are implied ...
Page 12
... Integrated Device Technology, Inc. All rights reserved. Product specifications subject to change without notice. IDT and the IDT logo are trademarks of Integrated Device Technology, Inc. Accelerated Thinking is a service mark of Integrated Device Technology, Inc. All other brands, product names and marks are or may be trademarks or registered trademarks used to identify products or services of their respective owners ...