PCA9554U,029 NXP Semiconductors, PCA9554U,029 Datasheet

no-image

PCA9554U,029

Manufacturer Part Number
PCA9554U,029
Description
I2C Interface IC PCA9554U/UNCASED/PUT
Manufacturer
NXP Semiconductors
Datasheet

Specifications of PCA9554U,029

Factory Pack Quantity
7000
1. General description
2. Features and benefits
The PCA9554 and PCA9554A are 16-pin CMOS devices that provide 8 bits of General
Purpose parallel Input/Output (GPIO) expansion for I
were developed to enhance the NXP Semiconductors family of I
The improvements include higher drive capability, 5 V I/O tolerance, lower supply current,
individual I/O configuration, 400 kHz clock frequency, and smaller packaging. I/O
expanders provide a simple solution when additional I/O is needed for ACPI power
switches, sensors, push buttons, LEDs, fans, and so on.
The PCA9554/PCA9554A consist of an 8-bit Configuration register (Input or Output
selection); 8-bit Input Port register, 8-bit Output Port register and an 8-bit Polarity
Inversion register (active HIGH or active LOW operation). The system master can enable
the I/Os as either inputs or outputs by writing to the I/O configuration bits. The data for
each input or output is kept in the corresponding Input Port or Output Port register. The
polarity of the read register can be inverted with the Polarity Inversion register. All
registers can be read by the system master. Although pin-to-pin and I
compatible with the PCF8574 series, software changes are required due to the
enhancements and are discussed in Application Note AN469.
The PCA9554/PCA9554A open-drain interrupt output is activated when any input state
differs from its corresponding Input Port register state and is used to indicate to the
system master that an input state has changed. The power-on reset sets the registers to
their default values and initializes the device state machine.
Three hardware pins (A0, A1, A2) vary the fixed I
devices to share the same I
except that the fixed I
(eight of each) on the same I
PCA9554; PCA9554A
8-bit I
Rev. 9 — 19 March 2013
Operating power supply voltage range of 2.3 V to 5.5 V
5 V tolerant I/Os
Polarity Inversion register
Active LOW interrupt output
Low standby current
Noise filter on SCL/SDA inputs
No glitch on power-up
Internal power-on reset
8 I/O pins which default to 8 inputs
0 Hz to 400 kHz clock frequency
2
C-bus and SMBus I/O port with interrupt
2
C-bus address is different allowing up to sixteen of these devices
2
C-bus/SMBus. The PCA9554A is identical to the PCA9554
2
C-bus/SMBus.
2
C-bus address and allow up to eight
2
C-bus/SMBus applications and
2
C-bus I/O expanders.
Product data sheet
2
C-bus address

Related parts for PCA9554U,029

Related keywords