KITPF0100EPEVBE Freescale Semiconductor, KITPF0100EPEVBE Datasheet - Page 45

• Manufacturer Part Number: KITPF0100EPEVBE
• Description: Power Management IC Development Tools MMPF0100 Eval Boar
• Manufacturer: Freescale Semiconductor
• Type: PMIC Solutionsr

Specifications of KITPF0100EPEVBE

• Rohs: yes
• Product: Evaluation Boards
• Tool Is For Evaluation Of: PF0100
• Input Voltage: 3.1 V to 4.5 V
• Output Voltage: 3.1 V to 4.5 V
• Description/function: Evaluation Board
• Interface Type: USB
• Output Current: 3 A to 5 A
• For Use With: PF0100

Freescale Semiconductor
Proceed by manually writing the desired commands or use the “Command” button to display a graphical command
selector in a new window, as shown in
The “Command” window contains a set of commands that are useful for automatically sequencing the PF0100
power supplies, thereby emulating system behavior. The “Command” window is organized in six sections, as
described below:
•
•
•
•
•
•
PF0100 - SWITCHING SUPPLIES> place a single script command with the selected buck regulator and the
desired function. The available functions are: mode selection, operating voltage setpoint, standby voltage
setpoint, OFF voltage setpoint, enable current limit and disable current limit. Note that for SW2, SW3A/B
and SW4, the VOLTS RANGE HIGH box need to be checked if the initial power up voltage is set to the high
voltage operating range. If working in the lower voltage range, leave the box unchecked.
PF0100 - LINEAR SUPPLIES> places a single script command with the selected LDO regulator and the
desired function. The available functions are: operating voltage setpoint, enable and disable output.
PF0100 - SWBST> Permits changing the operating voltage, as well as enabling and disabling the SWBST
output.
PROGRAMMER COMMANDS> Enables or disables the 3.3V supply as well as the ~8.0V boost supply on
the KITPF0100EPEVBE. Allows a progressive step-up/step-down of the ~8.0V output and controls the
general purpose output to set the PWRON terminal on the PF0100 high or set the same PWRON terminal
low or toggle a pulse that triggers a PWRON event.
OTHER COMMANDS> This section provides access to common instructions initiated by the control MCU.
The possible commands include delay, add separator bar, generic I
high, low or toggle.
LOG COMMAND> provide a log report of the actual status of a specific configuration on the PMIC. Syntax
for the log commands are shown in
Figure 40. Command Selector Window
Figure
Table
KTPF0100UG, Rev. 2.0
40.
8.
2
C write/read, set GPIO1 and GPIO2
Graphical User Interface Description
45