RS9110-N-11-02-EVB Redpine Signals, RS9110-N-11-02-EVB Datasheet - Page 15

• Manufacturer Part Number: RS9110-N-11-02-EVB
• Description: WiFi / 802.11 Development Tools RS9110-N-11-02 Evaluation Board
• Manufacturer: Redpine Signals

Specifications of RS9110-N-11-02-EVB

• Rohs: yes
• Product: Evaluation Boards
• Tool Is For Evaluation Of: RS9110-N-11-02
• Protocol Supported: 802.11 b/g/e/i
• Frequency: 2.4 GHz
• Interface Type: SDIO, SPI
• Operating Supply Voltage: 3.3 V
• Antenna Connector Type: Chip
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Modulation Technique: CCK, DSSS, OFDM

Redpine Signals, Inc. Proprietary and confidential
Pin No.
26)
27)
28)
29)
30)
31)
32)
33)
34)
35)
RS9110-N-11-02 802.11bgn WLAN Module
Pin Name
GND
VINBCKDC
GPIO_0
BT_PRIORITY
GND
WLAN_ACTIVE
SLEEP_CLK_IN
BT_ACTIVE
SLEEP_CLK_X2
SLEEP_CLK_X1
Version 1.49
Data Sheet
Pin Type
Ground
Power
Inout
Input
Ground
Output
Input
Input
Input
Input
Description
Ground
3.3 Volts input to the
PMU
General purpose input/output. In
the default configuration this is
programmed as an output and
should be left unconnected.
Indicates through ‘logic high’ that
BT is transmitting high priority
traffic. This is a firmware configured
GPIO pin. Where not used, it should
be left open.
Ground
When configured for BT
coexistence, this is an output and
indicates with logic high that WLAN
activity is in progress. When low,
BT device has the opportunity to
transmit. This is a firmware
configured GPIO pin. Where not
used, it should be left open.
Sleep clock input is NC for default
firmware.
An external 32KHz signal is fed to
this pin if the external 32KHz input
mode is selected. Please refer to
notes on Sleep Clock Input for more
details.
This signal may be used by an
external Bluetooth device to
indicate its activity or impending
activity. This signal is not used in
the default BT coexistence
firmware. This is a firmware
configured GPIO pin. Where not
used, it should be left open.
32KHz crystal connection
The pin should be left open except
as describe in mode (iii) as
described in note below for Sleep
Clock Input.
32KHz crystal connection
Page 15