RS9110-N-11-02-EVB Redpine Signals, RS9110-N-11-02-EVB Datasheet - Page 17

no-image

RS9110-N-11-02-EVB

Manufacturer Part Number
RS9110-N-11-02-EVB
Description
WiFi / 802.11 Development Tools RS9110-N-11-02 Evaluation Board
Manufacturer
Redpine Signals
Datasheet

Specifications of RS9110-N-11-02-EVB

Rohs
yes
Product
Evaluation Boards
Tool Is For Evaluation Of
RS9110-N-11-02
Protocol Supported
802.11 b/g/e/i
Frequency
2.4 GHz
Interface Type
SDIO, SPI
Operating Supply Voltage
3.3 V
Antenna Connector Type
Chip
Maximum Operating Temperature
+ 85 C
Minimum Operating Temperature
- 40 C
Modulation Technique
CCK, DSSS, OFDM

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
RS9110-N-11-02-EVB
Manufacturer:
RPS
Quantity:
4
Redpine Signals, Inc. Proprietary and confidential
Pin No.
50)
51)
52)
53)
54)
55)
RS9110-N-11-02 802.11bgn WLAN Module
Pin Name
MODE_SEL_0
MODE_SEL_1
VRF28
HOST_WAKEUP_IN
T
XTAL_EN_IP
GPIO_1
Version 1.49
Data Sheet
Pin Type
Input
Input
Power
Output
Input
Inout
Description
pin, this is the SPI Master clock
output. This is a firmware
configured GPIO pin. Where not
used, it should be left open. Default
firmware does not use this pin.
BOOT MODE: On no-connect, boot
parameters will be loaded from
internal flash. Should be left
unconnected so as to enable
bootloading.
SDIO MODE: No connect.
SPI Mode: Connect pull down of
4.7Kohms.
2.8 Volts LDO O/P
This pin is a GPIO. If this is not
used, it should be left open.
This pin is to be used by those
hosts which enter into power save
mode and which are not able to
detect the regular interrupt pin in
that power save mode.
If used as HOST_WAKEUP_INT, a
pull-up or pull-down of 100K has to
be connected on this pin
based on the polarity indicated to
the firmware.
Active low requires a pull-up.
Active high requires a pull-down.
This is a GPIO signal by default and
it should be left open.
If used, it can be configured
through firmware to be combined,
through a logical OR operation, with
the internal oscillator enable and
the output given on XTAL_EN pin.
This can be used when a crystal
oscillator is shared between the
WLAN module and other functional
blocks in the system.
General purpose input/output. In
the default configuration this is
programmed as an output and
should be left unconnected.
Page 17

Related parts for RS9110-N-11-02-EVB