MT46V64M8P-6T:F Micron Technology Inc, MT46V64M8P-6T:F Datasheet - Page 51

• Manufacturer Part Number: MT46V64M8P-6T:F
• Description: IC DDR SDRAM 512MBIT 6NS 66TSOP
• Manufacturer: Micron Technology Inc
• Type: DDR SDRAMr

Specifications of MT46V64M8P-6T:F

• Format - Memory: RAM
• Memory Type: DDR SDRAM
• Memory Size: 512M (64M x 8)
• Speed: 6ns
• Interface: Parallel
• Voltage - Supply: 2.3 V ~ 2.7 V
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 66-TSOP
• Organization: 64Mx8
• Density: 512Mb
• Address Bus: 15b
• Access Time (max): 700ps
• Maximum Clock Rate: 333MHz
• Operating Supply Voltage (typ): 2.5V
• Package Type: TSOP
• Operating Temp Range: 0C to 70C
• Operating Supply Voltage (max): 2.7V
• Operating Supply Voltage (min): 2.3V
• Supply Current: 175mA
• Pin Count: 66
• Mounting: Surface Mount
• Operating Temperature Classification: Commercial
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PRECHARGE (PRE)
Figure 20:
BURST TERMINATE (BST)
AUTO REFRESH (AR)
SELF REFRESH
PDF: 09005aef80a1d9d4/Source: 09005aef82a95a3a
DDR_x4x8x16_Core2.fm - 512Mb DDR: Rev. N; Core DDR Rev. B 2/09 EN
PRECHARGE Command
Notes:
The PRECHARGE command is used to deactivate the open row in a particular bank or
the open row in all banks as shown in Figure 20. The value on the BA0, BA1 inputs selects
the bank, and the A10 input selects whether a single bank is precharged or whether all
banks are precharged.
BA0, BA1
1. If A10 is HIGH, bank address becomes “Don’t Care.”
The BURST TERMINATE command is used to truncate READ bursts (with auto
precharge disabled). The most recently registered READ command prior to the BURST
TERMINATE command will be truncated, as shown in “Operations” on page 52. The
open page from which the READ burst was terminated remains open.
AUTO REFRESH is used during normal operation of the DDR SDRAM and is analogous
to CAS#-before-RAS# (CBR) refresh in FPM/EDO DRAMs. This command is nonpersis-
tent, so it must be issued each time a refresh is required. All banks must be idle before an
AUTO REFRESH command is issued.
The SELF REFRESH command can be used to retain data in the DDR SDRAM, even if the
rest of the system is powered down. The SELF REFRESH command is initiated like an
AUTO REFRESH command except CKE is disabled (LOW).
Self refresh is not supported on automotive temperature (AT) devices.
Address
RAS#
CAS#
WE#
CK#
CKE
A10
CS#
CK
HIGH
One bank
All banks
Bank1
Don’t Care
51
Micron Technology, Inc., reserves the right to change products or specifications without notice.
512Mb: x4, x8, x16 DDR SDRAM
©2000 Micron Technology, Inc. All rights reserved.
Commands