VIPER22ADIP-E STMicroelectronics, VIPER22ADIP-E Datasheet - Page 11

• Manufacturer Part Number: VIPER22ADIP-E
• Description: IC OFFLINE SWIT PWM SMPS 8DIP
• Manufacturer: STMicroelectronics
• Series: VIPER™r
• Type: Pulse Width Modulator Controllerr

Specifications of VIPER22ADIP-E

• Output Isolation: Isolated
• Frequency Range: 54 ~ 66kHz
• Voltage - Input: 8 ~ 50 V
• Voltage - Output: 730V
• Power (watts): 12W
• Operating Temperature: 25°C ~ 125°C
• Package / Case: 8-DIP (0.300", 7.62mm)
• Output Voltage: 38 V
• Output Power: 12 W
• Input Voltage: 0 V to 50 V
• Switching Frequency: 60 KHz
• Operating Temperature Range: - 40 C to + 150 C
• Mounting Style: Through Hole
• Current, Supply: 4.5 mA
• Frequency, Oscillator: 60 kHz
• Package Type: DIP-8
• Regulator Type: Switching
• Resistance, Thermal, Junction To Case: 15 °C/W
• Temperature, Operating, Range: -40 to +150 °C
• Time, Fall: 100 ns
• Time, Rise: 50 ns
• Voltage, Supply: 18 V
• Supply Voltage: 38V
• Digital Ic Case Style: DIP
• No. Of Pins: 8
• No. Of Regulated Outputs: 1
• Filter Terminals: DIP
• Rohs Compliant: Yes
• For Use With: 497-9049 - BOARD EVAL BASED VIPER22ASTR-E497-8215 - BOARD EVAL BASED ON VIPER22A497-5864 - EVAL BOARD DUAL OUTPUT VIPER22A497-5071 - EVAL BOARD DIMMABLE HB PWR LEDVIPER22-LED-EV - VIPER LED POWER SUPPLY
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-7694-5; VIPER22ADIP-E

VIPer22A-E, VIPer22ADIP-E, VIPer22AS-E
4.4
Startup sequence
Figure 7.
This device includes a high voltage start up current source connected on the drain of the
device. As soon as a voltage is applied on the input of the converter, this start up current
source is activated as long as V
current source is switched OFF and the device begins to operate by turning on and off its
main power MOSFET. As the FB pin does not receive any current from the optocoupler, the
device operates at full current capacity and the output voltage rises until reaching the
regulation point where the secondary loop begins to send a current in the optocoupler. At
this point, the converter enters a regulated operation where the FB pin receives the amount
of current needed to deliver the right power on secondary side.
This sequence is shown in
consumes some energy from the V
continuous supply. If the value of this capacitor is too low, the start up phase is terminated
before receiving any energy from the auxiliary winding and the converter never starts up.
This is illustrated also in the same figure in dashed lines.
Startup sequence
Figure 7
Doc ID 12050 Rev 2
DD
DD
. Note that during the real starting phase t
is lower than V
capacitor, waiting for the auxiliary winding to provide a
DDon
. When reaching V
DDon
ss
, the start up
, the device
Operations
11/21