TNY254P Power Integrations, TNY254P Datasheet - Page 12

• Manufacturer Part Number: TNY254P
• Description: IC OFFLINE SWIT OTP OCP HV 8DIP
• Manufacturer: Power Integrations
• Series: TinySwitch®r

Specifications of TNY254P

• Output Isolation: Isolated
• Frequency Range: 40 ~ 48kHz
• Voltage - Output: 700V
• Power (watts): 4W
• Operating Temperature: -40°C ~ 150°C
• Package / Case: 8-DIP (0.300", 7.62mm)
• Output Voltage: 5.8 V
• Input / Supply Voltage (max): 265 VAC
• Input / Supply Voltage (min): 85 VAC
• Duty Cycle (max): 68 %
• Switching Frequency: 44 KHz
• Supply Current: 140 uA
• Operating Temperature Range: - 40 C to + 150 C
• Mounting Style: Through Hole
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

NOTES:
A. For a threshold with a negative value, negative hysteresis is a decrease in magnitude of the corresponding threshold.
B. Total current consumption is the sum of I
C. Since the output MOSFET is switching, it is difficult to isolate the switching current from the supply current at the
D. Bypass pin is not intended for sourcing supply current to external circuitry.
E. See typical performance characteristics section for BYPASS pin start-up charging waveform.
F. For current limit at other di/dt values, refer to current limit vs. di/dt curve under typical performance
G. This parameter is derived from the change in current limit measured at 5X and 10X of the di/dt shown in the I
Figure 14. TinySwitch General Test Circuit.
12
TNY253/254/255
DRAIN Supply
Voltage
Output Enable
Delay
Output Disable
Setup Time
OUTPUT (cont.)
and the sum of I
DRAIN. An alternative is to measure the BYPASS pin current at 6.2 V.
characteristics.
specification.
Parameter
D
4/03
NOTE: This test circuit is not applicable for current limit or output characteristic measurements.
S2
and I
Symbol
DSS
S
S
D
S
t
t
DST
EN
when ENABLE pin is open (MOSFET switching).
EN
BP
S
S
SOURCE = 0 V; T
(Unless Otherwise Specified)
See Figure 16
S1
and I
0.1 µF
Conditions
See Figure 14
DSS
when ENABLE pin is shorted to ground (MOSFET not switching)
J
= -40 to 125 °C
S1
470 Ω
5 W
TNY253
TNY254
TNY255
10 V
470 Ω
S2
Min
50
Typ
0.5
50 V
Max
14
10
Units
PI-2211-061898
µs
µs
V
LIMIT