L6564D STMicroelectronics, L6564D Datasheet - Page 18
![no-image](/images/manufacturer_photos/0/6/637/stmicroelectronics_sml.jpg)
L6564D
Manufacturer Part Number
L6564D
Description
IC PFC CTRLR TRANSITION 10SSOP
Manufacturer
STMicroelectronics
Datasheet
1.L6564DTR.pdf
(33 pages)
Specifications of L6564D
Mode
Discontinuous (Transition)
Frequency - Switching
1MHz
Current - Startup
90µA
Voltage - Supply
10.3 V ~ 22.5 V
Operating Temperature
-25°C ~ 125°C
Mounting Type
Surface Mount
Package / Case
10-SSOP
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
L6564
L6564
L6564
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
L6564D
Manufacturer:
STMicroelectronics
Quantity:
480
Part Number:
L6564D
Manufacturer:
ST
Quantity:
20 000
Part Number:
L6564DTR
Manufacturer:
ST
Quantity:
20 000
Application information
6
6.1
18/33
Application information
Overvoltage protection
Normally, the voltage control loop keeps the output voltage Vo of the PFC pre-regulator
close to its nominal value, set by the ratio of the resistors R1 and R2 of the output divider. A
pin of the device (PFC_OK) has been dedicated to monitor the output voltage with a
separate resistor divider (R3 high, R4 low, see
the voltage at the pin reaches 2.5 V if the output voltage exceeds a preset value, usually
larger than the maximum Vo that can be expected.
Example: V
51 kΩ.
When this function is triggered, the gate drive activity is immediately stopped until the
voltage on the pin PFC_OK drops below 2.4 V. Notice that R1, R2, R3 and R4 can be
selected without any constraints. The unique criterion is that both dividers have to sink a
current from the output bus which needs to be significantly higher than the bias current of
both INV and PFC_OK pins.
Figure 27. Output voltage setting, OVP and FFP functions: internal block diagram
O
= 400 V, V
OX
= 434 V. Select: R3 = 8.8 MΩ; then: R4 = 8.8 MΩ ·2.5/(434-2.5) =
Doc ID 16202 Rev 2
Figure
27). This divider is selected so that
L6564