HCPL-2430#500 Avago Technologies US Inc., HCPL-2430#500 Datasheet - Page 15
![ISOLAT 3.75KVRMS 2CH UNIDIR 8SMD](/photos/15/83/158318/dual_inline_gull_wing_sml.jpg)
HCPL-2430#500
Manufacturer Part Number
HCPL-2430#500
Description
ISOLAT 3.75KVRMS 2CH UNIDIR 8SMD
Manufacturer
Avago Technologies US Inc.
Datasheet
1.HCPL-2400-300E.pdf
(15 pages)
Specifications of HCPL-2430#500
Package / Case
8-SMD Gull Wing
Voltage - Isolation
3750Vrms
Number Of Channels
2, Unidirectional
Current - Output / Channel
25mA
Data Rate
40MBd
Propagation Delay High - Low @ If
33ns @ 7mA
Current - Dc Forward (if)
10mA
Input Type
DC
Output Type
Push-Pull, Totem-Pole
Mounting Type
Surface Mount, Gull Wing
Isolation Voltage
3750 Vrms
Maximum Continuous Output Current
25 mA
Maximum Fall Time
10 ns
Maximum Forward Diode Current
10 mA
Maximum Rise Time
20 ns
Minimum Forward Diode Voltage
1.1 V
Output Device
Logic Gate Photo IC
Configuration
2 Channel
Maximum Baud Rate
40 MBps
Maximum Forward Diode Voltage
1.5 V
Maximum Reverse Diode Voltage
2 V
Maximum Power Dissipation
350 mW
Maximum Operating Temperature
+ 70 C
Minimum Operating Temperature
0 C
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Switching performance of the HCPL-2400/30 optocou-
plers is not sensitive to the TTL logic family used in the
recommended drive circuit. The typical and worst-case
switching parameters given in the data sheet can be
met using common 74LS TTL inverting gates or buffers.
Use of faster TTL families will slightly reduce the overall
propagation delays from the input of the drive circuit to
For product information and a complete list of distributors, please go to our website:
Avago, Avago Technologies, and the A logo are trademarks of Avago Technologies Limited in the United States and other countries.
Data subject to change. Copyright © 2007 Avago Technologies Limited. All rights reserved. Obsoletes AV01-0563EN
AV02-0962EN - January 4, 2008
www.avagotech.com
the output of the optocoupler, but will not necessarily
result in lower pulse-width distortion or propagation de-
lay skew. This reduction in overall propagation delay is
due to shorter delays in the drive circuit, not to changes
in the propagation delays of the optocoupler; optocou-
pler propagation delays are not affected by the speed of
the logic used in the drive circuit.