PS2707-1-A CEL, PS2707-1-A Datasheet - Page 9
![no-image](/images/manufacturer_photos/0/1/129/cel_sml.jpg)
PS2707-1-A
Manufacturer Part Number
PS2707-1-A
Description
PHOTOCOUPLER 1CH TRANS OUT SM
Manufacturer
CEL
Series
NEPOCr
Datasheet
1.PS2707-1-A.pdf
(12 pages)
Specifications of PS2707-1-A
Number Of Channels
1
Input Type
AC, DC
Voltage - Isolation
3750Vrms
Current Transfer Ratio (min)
10% @ 1mA
Current Transfer Ratio (max)
400% @ 5mA
Voltage - Output
120V
Current - Output / Channel
30mA
Current - Dc Forward (if)
±50mA
Vce Saturation (max)
300mV
Output Type
Transistor
Mounting Type
Surface Mount
Package / Case
4-SMD
Maximum Fall Time
10 us
Maximum Input Diode Current
50 mA
Maximum Rise Time
10 us
Maximum Collector Emitter Voltage
120 V
Maximum Collector Emitter Saturation Voltage
0.3 V
Isolation Voltage
3750 Vrms
Current Transfer Ratio
400 %
Maximum Forward Diode Voltage
1.4 V
Maximum Collector Current
30 mA
Maximum Power Dissipation
150 mW
Maximum Operating Temperature
+ 100 C
Minimum Operating Temperature
- 55 C
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
NOTES ON HANDLING
1. Recommended soldering conditions
(1) Infrared reflow soldering
(2) Wave soldering
(3) Cautions
2. Cautions regarding noise
collector-emitters at startup, the output side may enter the on state, even if the voltage is within the absolute
maximum ratings.
• Peak reflow temperature
• Time of peak reflow temperature
• Time of temperature higher than 220°C
• Time to preheat temperature from 120 to 180°C
• Number of reflows
• Flux
• Temperature
• Time
• Preheating conditions
• Number of times
• Flux
• Fluxes
Be aware that when voltage is applied suddenly between the photocoupler’s input and output or between
Avoid removing the residual flux with freon-based and chlorine-based cleaning solvent.
260°C or below (molten solder temperature)
10 seconds or less
120°C or below (package surface temperature)
One (Allowed to be dipped in solder including plastic mold portion.)
Rosin flux containing small amount of chlorine (The flux with a maximum chlorine
content of 0.2 Wt% is recommended.)
Recommended Temperature Profile of Infrared Reflow
120˚C
(preheating)
120±30 s
Data Sheet PN10245EJ01V0DS
180˚C
260°C or below (package surface temperature)
10 seconds or less
60 seconds or less
120±30 s
Three
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
Time (s)
(heating)
to 60 s
to 10 s
260˚C MAX.
220˚C
PS2707-1
9