PV36Z104C01B00 Murata Electronics North America, PV36Z104C01B00 Datasheet - Page 19
![TRIM POT CERM 100KOHM 25TRN SIDE](/photos/8/48/84834/pv36z_series_sml.jpg)
PV36Z104C01B00
Manufacturer Part Number
PV36Z104C01B00
Description
TRIM POT CERM 100KOHM 25TRN SIDE
Manufacturer
Murata Electronics North America
Series
PV36r
Datasheets
1.PVZ3A503A01R00.pdf
(1 pages)
2.PV36W102C01B00.pdf
(1 pages)
3.PV36W102C01B00.pdf
(22 pages)
Specifications of PV36Z104C01B00
Resistance (ohms)
100K
Power (watts)
0.5W, 1/2W
Taper
Linear
Tolerance
±10%
Temperature Coefficient
±100ppm/°C
Number Of Turns
25
Adjustment Type
Side Adjustment
Mounting Type
Through Hole
Resistive Material
Cermet
Package / Case
Square - 0.378" L x 0.197" W x 0.394" H (9.60mm x 5.00mm x 10.00mm)
Resistance In Ohms
100K
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
490-2933
8
!Note
!Note
1. Use suitable screwdrivers that fit comfortably in
2. Don't apply more than 9.8N (Ref.; 1kgf) of twist
1. Please make sure that your product has been
2. Murata cannot guarantee trimmer potentiometer
72
PV12/PV37/PV23/PV22/PV36 Series Notice
Notice (Handling)
driver slot. We recommend the screwdrivers below.
* Recommended screwdriver for manual adjustment
We can supply the screwdrivers above.
If you place order, please specify the Murata P/N.
and stress after mounting onto PCB to prevent
contact intermittence. If excessive force is
Notice (Other)
evaluated and confirmed against your
specifications when our product is mounted to your
product.
integrity when used under conditions other than
those specified in this document.
ENGINEER INC. : DA-40
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this PDF catalog to prevent smoking and/or burning, etc.
This catalog has only typical specifications. Therefore, you are requested to approve our product specifications or to transact the approval sheet for product specifications before ordering.
(Murata P/N : KMDR180)
3. When adjusting with an adjustment tool, the applied
4. When using a lock paint to fix slot position,
applied, the trimmer potentiometer may not
function.
force to the adjustment screw should not exceed
4.9N (Ref.; 500gf). If excessive force is applied,
the trimmer potentiometer may not function due to
damage.
please use adhesive resin without chlorine or
sulfur (Three-bond "1401 series").
R50E13.pdf 04.6.11