AT89ISP Atmel, AT89ISP Datasheet
AT89ISP
Specifications of AT89ISP
Related parts for AT89ISP
AT89ISP Summary of contents
Page 1
... AT89ISP Cable In order to use the AT89ISP software, the user will need to have an Atmel AT89ISP cable. This cable can be purchased directly from Atmel or authorized Atmel represen- tatives. The ISP cable's pins need to be connected to an AT89S/AT89LP device in the ...
Page 2
... Figure 5-1. 6. Connection The correct way to connect the female header end of the AT89ISP cable to the 10-pin receptacle male header is to align the connector “arrow” towards pin 1, as illustrated in cable casing end, make sure the connector “arrow” sits visible next to the side of the small PC board (not away from it) ...
Page 3
... Figure 6-2. 7. Voltage Levels The AT89ISP cable requires a regulated DC supply from the user target board. The cable should operate correctly between the specified operating voltage limits. The current operating V voltage range for the AT89ISP cable is 2.7V to 5.5V. CC 3310E–MICRO–10/06 AT89ISP Programmer Cable ...
Page 4
... Disclaimer: The information in this document is provided in connection with Atmel products. No license, express or implied, by estoppel or otherwise, to any intellectual property right is granted by this document or in connection with the sale of Atmel products. EXCEPT AS SET FORTH IN ATMEL’S TERMS AND CONDI- TIONS OF SALE LOCATED ON ATMEL’S WEB SITE, ATMEL ASSUMES NO LIABILITY WHATSOEVER AND DISCLAIMS ANY EXPRESS, IMPLIED OR STATUTORY WARRANTY RELATING TO ITS PRODUCTS INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT ...