EZ801900100ZAC Zilog, EZ801900100ZAC Datasheet - Page 9

• Manufacturer Part Number: EZ801900100ZAC
• Description: KIT THERMOSTAT APPLICATION MOD
• Manufacturer: Zilog

Specifications of EZ801900100ZAC

• Accessory Type: Thermostat Application Module
• For Use With/related Products: eZ80 Dev. Platforms
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 269-3198; EZ801900100ZAC

8. The default IP address of the ZPAK II unit is
Changing ZPAK II Settings to Match the PC
There are two ways to change the ZPAK II’s default settings. One method is via the
ZPAK II embedded web page via a browser over an Ethernet connection. The other way is
via the ZPAK II console port. The following steps describe the console port method.
1. The serial port of the PC should already be connected to the console serial port of the
2. Launch HyperTerminal on the PC by navigating from the Start menu to Programs
3. Create a new connection in HyperTerminal by selecting the appropriate COM port in
4. If you select COM1, the COM1 Properties dialog appears. Enter the following port
5. Ensure that the connection is in the Connected state by observing the HyperTerminal
6. While holding down the z key (lowercase) on the PC’s keyboard, press the RESET
QS000413-0606
Note:
Note:
with another address on the LAN, or if another address is more compatible, proceed to
the next section; otherwise, proceed to the
ZPAK II unit.
→ Accessories → HyperTerminal or Accessories → Communications → Hyper-
Terminal, depending upon your Windows OS.
the Connect using: field of the Connect To dialog. Click OK.
settings and click OK.
status bar. If not connected, select Connect from the Call menu.
button on the side of the ZPAK II. Releasing the z key displays a ZPAK II console
boot-up message in HyperTerminal, followed by the
2
To change the ZPAK II settings from their defaults via a web browser, please consult the ZPAK II Debug
Interface Tool Product User Guide (PUG0015).
Bits per second:
Data bits:
Parity:
Stop bits:
Flow control:
This connection is a direct connection via a COM port, not a modem.
To locate the Reset button, view the ZPAK II debug interface tool with the
XTools® logo reading top-side up. The Reset button is recessed within the
57600
8
None
2
None
Running Sample Projects
192.168.1.50
ZPAK
eZ80190 Development Kit
prompt, as shown below.
. If this address conflicts
Configure the Hardware
Quick Start Guide
section on page 11.
Page 9
2