ATF15XXDK3-SAJ44 Atmel, ATF15XXDK3-SAJ44 Datasheet - Page 33

• Manufacturer Part Number: ATF15XXDK3-SAJ44
• Description: ADAPTER SKT ATF15XXBE 84/44PLCC
• Manufacturer: Atmel

Specifications of ATF15XXDK3-SAJ44

• Module/board Type: Socket Module - PLCC
• For Use With/related Products: ATF15xxDK3
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

3605B–PLD–05/06
CPLD Design Flow Tutorial
3-12
The next step requires you to setup the Atmel ATF15xx-DK3 CPLD Development/Pro-
grammer Board to program the ATF1502BE-7AU44 through the CPLD ISP cable.
7. Connect the DB25 side of the Atmel CPLD ISP MV cable (Revision 6) to the PC’s
8. Connect a 9V AC/DC power supply to the power connector (JPower) of the Atmel
9. Set the VCCIO Selector jumper to the 1.8V(BE) position for supplying the core
Note:
10. Set the JPCLK jumper to GCLK1 so that the output of the crystal oscillator will go
11. Set the JPJTAG Jumper ISP Cable position, which is toward the middle of the
12. Connect the 44-pin TQFP Socket Adapter Board onto the main develop-
Note:
13. Select which LPT port is being used for Atmel CPLD ISP cable in the Port Setting
14. Select the ISP download cable type in the Cable Type field. The default cable
Note:
15. Switch the power switch to the ON position.
JEDEC file. Click OK to close the JTAG Device Properties window when all prop-
erties are specified.
parallel port and the 10-pin header side of the cable to the Atmel ATF15xx-DK3
CPLD Development Board as shown Figure 2-10 on page 2-14.
ATF15xx-DK3 CPLD Development/Programmer Board.
voltage of the ATF1502BE device at 1.8V, then set the VCCINT Selector jumper
to the 1.8V(BE) position for supplying the I/O pad voltage of the ATF1502BE
device at 1.8V.
to pin 37 (GCLK1) of the ATF1502BE. For this design, you can also set the
JPCLK jumper to GCLK2 so that the output of the crystal oscillator will go to pin
40 (GCLK2) of the ATF1502BE for selecting another global clock source.
board.
ment/programmer board.
field. LPT1 is the default port and it represents address 0x378.
type is the “Atmel CPLD-ISP MV”, which represents the Atmel CPLD ISP Cable
Rev 6.0, but it can be changed to other cables that can be used for other devices.
Make sure the ICCINT and ICCIO jumpers are in their default positions. These
two jumpers are only removed when you are connecting them from two poles of
the digital multimeter to perform current measurement.
If a device in a different package type is to be programmed, then the appropri-
ate Socket Adapter Board must be used.
The “Atmel CPLD-ISP” cable type represents the Atmel CPLD ISP Cable Rev
5.0 or older.
(4) Specify target
(5) Specify JTAG
(6) Select JEDEC
device type
instruction
file
ATF15xx-DK3 Development Kit User Guide