C8051T600SDB Silicon Laboratories Inc, C8051T600SDB Datasheet - Page 121

• Manufacturer Part Number: C8051T600SDB
• Description: BOARD SOCKET DAUGHTER SOIC
• Manufacturer: Silicon Laboratories Inc

Specifications of C8051T600SDB

• Module/board Type: Socket Module - SOIC
• Data Bus Width: 8 bit
• Operating Supply Voltage: + 1.8 V to + 3.6 V
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: C8051T600DK
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1405

23.1. Supporting Documents
It is assumed the reader is familiar with or has access to the following supporting documents:
1. The I
2. The I
3. System Management Bus Specification—Version 1.1, SBS Implementers Forum.
23.2. SMBus Configuration
Figure 23.2 shows a typical SMBus configuration. The SMBus specification allows any recessive voltage
between 3.0 V and 5.0 V; different devices on the bus may operate at different voltage levels. The bi-direc-
tional SCL (serial clock) and SDA (serial data) lines must be connected to a positive power supply voltage
through a pullup resistor or similar circuit. Every device connected to the bus must have an open-drain or
open-collector output for both the SCL and SDA lines, so that both are pulled high (recessive state) when
the bus is free. The maximum number of devices on the bus is limited only by the requirement that the rise
and fall times on the bus not exceed 300 ns and 1000 ns, respectively.
23.3. SMBus Operation
Two types of data transfers are possible: data transfers from a master transmitter to an addressed slave
receiver (WRITE), and data transfers from an addressed slave transmitter to a master receiver (READ).
The master device initiates both types of data transfers and provides the serial clock pulses on SCL. The
SMBus interface may operate as a master or a slave, and multiple master devices on the same bus are
supported. If two or more masters attempt to initiate a data transfer simultaneously, an arbitration scheme
is employed with a single master always winning the arbitration. Note that it is not necessary to specify one
device as the Master in a system; any device that transmits a START and a slave address becomes the
master for the duration of that transfer.
A typical SMBus transaction consists of a START condition followed by an address byte (Bits7–1: 7-bit
slave address; Bit0: R/W direction bit), one or more bytes of data, and a STOP condition. Bytes that are
received (by a master or slave) are acknowledged (ACK) with a low SDA during a high SCL (see
Figure 23.3). If the receiving device does not ACK, the transmitting device will read a NACK (not acknowl-
edge), which is a high SDA during a high SCL.
The direction bit (R/W) occupies the least-significant bit position of the address byte. The direction bit is set
to logic 1 to indicate a "READ" operation and cleared to logic 0 to indicate a "WRITE" operation.
VDD = 5V
2
2
C-Bus and How to Use It (including specifications), Philips Semiconductor.
C-Bus Specification—Version 2.0, Philips Semiconductor.
Figure 23.2. Typical SMBus Configuration
VDD = 3V
Master
Device
Rev. 1.2
Device 1
VDD = 5V
Slave
C8051T600/1/2/3/4/5/6
VDD = 3V
Device 2
Slave
SDA
SCL
121