C8051T610DB28 Silicon Laboratories Inc, C8051T610DB28 Datasheet - Page 94

DAUGHTER BOARD T610 28QFN SOCKET

C8051T610DB28

Manufacturer Part Number
C8051T610DB28
Description
DAUGHTER BOARD T610 28QFN SOCKET
Manufacturer
Silicon Laboratories Inc
Datasheet

Specifications of C8051T610DB28

Module/board Type
Socket Module - QFN
Processor To Be Evaluated
C8051T61x
Interface Type
USB
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
C8051T610DK
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
Other names
336-1506
C8051T610/1/2/3/4/5/6/7
17. EPROM Memory
Electrically programmable read-only memory (EPROM) is included on-chip for program code storage. The
EPROM memory can be programmed via the C2 debug and programming interface when a special pro-
gramming voltage is applied to the V
pin. Each location in EPROM memory is programmable only once
PP
(i.e., non-erasable). Table 7.6 on page 34 shows the EPROM specifications.
17.1. Programming and Reading the EPROM Memory
Reading and writing the EPROM memory is accomplished through the C2 programming and debug inter-
face. When creating hardware to program the EPROM, it is necessary to follow the programming steps
listed below. Refer to the “C2 Interface Specification” available at http://www.silabs.com for details on com-
municating via the C2 interface. Section “27. C2 Interface” on page 208 has information about C2 register
addresses for the C8051T610/1/2/3/4/5/6/7.
17.1.1. EPROM Write Procedure
1. Reset the device using the RST pin.
2. Wait at least 20 µs before sending the first C2 command.
3. Place the device in core reset: Write 0x04 to the DEVCTL register.
4. Set the device to program mode (1st step): Write 0x40 to the EPCTL register.
5. Set the device to program mode (2nd step): Write 0x58 to the EPCTL register.
6. Apply the VPP programming Voltage.
7. Write the first EPROM address for programming to EPADDRH and EPADDRL.
8. Write a data byte to EPDAT. EPADDRH:L will increment by 1 after this write.
9. Use a C2 Address Read command to poll for write completion.
10.(Optional) Check the ERROR bit in register EPSTAT and abort the programming operation if necessary.
11. If programming is not finished, return to Step 8 to write the next address in sequence, or return to
Step 7 to program a new address.
12.Remove the VPP programming Voltage.
13.Remove program mode (1st step): Write 0x40 to the EPCTL register.
14.Remove program mode (2nd step): Write 0x00 to the EPCTL register.
15.Reset the device: Write 0x02 and then 0x00 to the DEVCTL register.
Important Note: There is a finite amount of time which V
can be applied without damaging the device,
PP
which is cumulative over the life of the device. Refer to Table 7.1 on page 31 for the V
timing specifica-
PP
tion.
94
Rev 1.0

Related parts for C8051T610DB28