OM6290 NXP Semiconductors, OM6290 Datasheet - Page 29

• Manufacturer Part Number: OM6290
• Description: DEMO BOARD LCD GRAPHIC DRIVER
• Manufacturer: NXP Semiconductors

Specifications of OM6290

• Main Purpose: Displays, LCD Controller
• Embedded: Yes, MCU, 16/32-Bit
• Utilized Ic / Part: PCF2119, PCF8531, PCF8576
• Primary Attributes: Character, Graphic and Segment LCD Drivers
• Secondary Attributes: JTAG, I²C, UART & USB Interfaces
• Description/function: Demo Board
• Interface Type: USB, I2C, JTAG, UART
• Data Bus Width: 4 bit, 8 bit, 16 bit
• Operating Voltage: 1.8 V to 5.5 V
• For Use With/related Products: PCF8576DT, PCF2119S, PCF8531
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 568-4703

NXP Semiconductors
PCF8531
Product data sheet
10.1.4 Acknowledge
The number of data bytes transferred between the START and STOP conditions from
transmitter to receiver is unlimited. Each byte of eight bits is followed by an acknowledge
cycle.
Acknowledgement on the I
Fig 16. System configuration
•
•
•
•
•
•
•
Multi-master: more than one master can attempt to control the bus at the same time
without corrupting the message
Arbitration: procedure to ensure that, if more than one master simultaneously tries to
control the bus, only one is allowed to do so and the message is not corrupted
Synchronization: procedure to synchronize the clock signals of two or more devices.
A slave receiver which is addressed must generate an acknowledge after the
reception of each byte.
Also a master receiver must generate an acknowledge after the reception of each
byte that has been clocked out of the slave transmitter.
The device that acknowledges must pull-down the SDA line during the acknowledge
clock pulse, so that the SDA line is stable LOW during the HIGH period of the
acknowledge related clock pulse (set-up and hold times must be taken into
consideration).
A master receiver must signal an end of data to the transmitter by not generating an
acknowledge on the last byte that has been clocked out of the slave. In this event the
transmitter must leave the data line HIGH to enable the master to generate a STOP
condition.
SCL
SDA
TRANSMITTER/
RECEIVER
MASTER
All information provided in this document is subject to legal disclaimers.
Rev. 05 — 10 August 2010
RECEIVER
2
C-bus is shown in
SLAVE
TRANSMITTER/
RECEIVER
SLAVE
Figure
17.
TRANSMITTER
MASTER
34 x 128 pixel matrix driver
PCF8531
TRANSMITTER/
© NXP B.V. 2010. All rights reserved.
RECEIVER
MASTER
mga807
29 of 51