ATSTK600 Atmel, ATSTK600 Datasheet - Page 21

• Manufacturer Part Number: ATSTK600
• Description: DEV KIT FOR AVR/AVR32
• Manufacturer: Atmel
• Series: AVR®r
• Type: MCUr

Specifications of ATSTK600

• Processor To Be Evaluated: AVR and AVR32
• Data Bus Width: 8 bit
• Interface Type: RS-232, USB
• Silicon Manufacturer: Atmel
• Core Architecture: AVR
• Core Sub-architecture: AVR UC3
• Silicon Core Number: STK600
• Silicon Family Name: AVR
• Kit Contents: Board
• Rohs Compliant: Yes
• For Use With/related Products: Atmel AVR Devices
• For Use With: ATSTK600-ATTINY10 - STK600-ATTINY10 SOCKET PACKAGE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Contents: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Table 6-2. Answer format.
6.2 CMD_LEAVE_PROGMODE_HVSP
Table 6-3. Command format.
Table 6-4. Answer format.
6.3 CMD_CHIP_ERASE_HVSP
Field
PowoffDelay
resetDelay1
resetDelay2
Field
Answer ID
Status
Field
Command ID
stabDelay
resetDelay
Field
Answer ID
Status
8133A-AVR-04/08
Size
1 byte
1 byte
1 byte
Size
1 byte
1 byte
Size
1 byte
1 byte
1 byte
Size
1 byte
1 byte
This command will make the target device leave programming mode if it succeeds.
XML path: /AVRPART/ICE_SETTINGS/STK600/HvspLeaveProgMode/
This command will perform a chip erase on the target device if it succeeds.
XML path: /AVRPART/ICE_SETTINGS/STK600/HvspChipErase/
Values
XML: powoffDelay
XML: resetDelay1
XML: resetDelay2
Values
CMD_ENTER_PROGMODE_H
VSP
STATUS_CMD_OK or
STATUS_CMD_FAILED
Values
CMD_LEAVE_PROGMODE_HV
SP
XML: stabDelay
XML: resetDelay
Values
CMD_LEAVE_PROGMODE_HV
SP
STATUS_CMD_OK
Description
Power-off delay. Additional delay (in ms) after Vtg
is turned off in order to make sure the Vtg is low
enough
RSTDELAY #1 (in ms) Additional delay between
Vtg is turned on and reset goes high.
RSTDELAY #2(in us x 10) Additional delay
between Vtg is turned on and reset goes high.
Total delay is RSTDELAY #1 (ms) + RSTDELAY
#2 (us x 10)
Description
Answer id
A Result Value indicating the result of the
operation. If failed the target voltage is >5.5V or
<4.5V
Description
Command id
Delay (in ms) used for pin stabilization
Delay (in ms) in connection with the
LeaveProgMode command execution and
Reset_low_duration
Description
Answer id
A Result Value indicating the result of the
operation. Will always read OK
AVR079
21