C8051F410DK Silicon Laboratories Inc, C8051F410DK Datasheet - Page 77

• Manufacturer Part Number: C8051F410DK
• Description: KIT DEV FOR C8051F41X
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F410DK

• Contents: Evaluation Board, Power Supply, USB Cables, Adapter and Documentation
• Processor To Be Evaluated: C8051F41x
• Interface Type: USB
• Silicon Manufacturer: Silicon Labs
• Core Architecture: 8051
• Silicon Core Number: C8051F410
• Silicon Family Name: C8051F41x
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: Silicon Laboratories C8051F41x
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1314

C8051F410/1/2/3
7.
Voltage Reference
The Voltage reference MUX on C8051F41x devices is configurable to use an externally connected voltage
reference, the internal reference voltage generator, or the V
power supply voltage (see Figure 7.1). The
DD
REFSL bit in the Reference Control register (REF0CN) selects the reference source. For an external
source or the internal reference, REFSL should be set to ‘0’. To use V
as the reference source, REFSL
DD
should be set to ‘1’.
The internal voltage reference circuit consists of a temperature stable bandgap voltage reference genera-
tor and a gain-of-two output buffer amplifier. The output voltage is selected between 1.5 V and 2.2 V. The
internal voltage reference can be driven out on the V
pin by setting the REFBE bit in register REF0CN
REF
to a ‘1’ (see Figure 7.1). The load seen by the V
pin must draw less than 200 µA to GND. When using
REF
the internal voltage reference, bypass capacitors of 0.1 µF and 4.7 µF are recommended from the V
REF
pin to GND. If the internal reference is not used, the REFBE bit should be cleared to ‘0’.
The BIASE bit enables the internal voltage bias generator, which is used by the ADC, Temperature Sensor,
internal oscillators, and IDACs. This bit is forced to logic 1 when any of the aforementioned peripherals are
enabled. The bias generator may be enabled manually by writing a ‘1’ to the BIASE bit in register
REF0CN; see SFR Definition 7.1 for REF0CN register details.
The electrical specifications for the voltage reference circuit are given in Table 7.1.
REFLV
Figure 7.1. Voltage Reference Functional Block Diagram
Rev. 1.1
77