R0K561622S000BE Renesas Electronics America, R0K561622S000BE Datasheet - Page 649

• Manufacturer Part Number: R0K561622S000BE
• Description: KIT STARTER FOR H8SX/1622
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K561622S000BE

• Contents: Board, Cables, CD, Debugger, Power Supply
• Silicon Manufacturer: Renesas
• Features: Coding And Debugging, E10A Emulator, RS232 Serial Connection
• Kit Contents: Board
• Silicon Family Name: H8SX/1622F
• Silicon Core Number: R5F61622N50LGV
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: H8SX/1622
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Note:
Bit
3
2
1
0
*
Bit Name
PER
TEND
MPB
MPBT
Only 0 can be written, to clear the flag.
Initial
Value
0
1
0
0
R/W
R/(W)* Parity Error
R
R
R/W
Description
Indicates that a parity error has occurred during
reception in asynchronous mode and the reception
ends abnormally.
[Setting condition]
•
[Clearing condition]
•
Transmit End
[Setting conditions]
•
•
[Clearing conditions]
•
•
Multiprocessor Bit
Stores the multiprocessor bit value in the receive frame.
When the RE bit in SCR is cleared to 0 its previous
state is retained.
Multiprocessor Bit Transfer
Sets the multiprocessor bit value to be added to the
transmit frame.
When a parity error is detected during reception
Receive data when the parity error occurs is
transferred to RDR, however, the RDRF flag is not
set. Note that when the PER flag is being set to 1,
the subsequent serial reception cannot be
performed. In clocked synchronous mode, serial
transmission also cannot continue.
When 0 is written to PER after reading PER = 1
Even when the RE bit in SCR is cleared, the PER
bit is not affected and retains its previous value.
(When the CPU is used to clear this flag by writing 0
while the corresponding interrupt is enabled, be
sure to read the flag after writing 0 to it.)
When the TE bit in SCR is 0
When TDRE = 1 at transmission of the last bit of a
transmit character
When 0 is written to TDRE after reading TDRE = 1
When a TXI interrupt request is issued allowing
DMAC or DTC to write data to TDR
Section 16 Serial Communication Interface (SCI)
Rev. 2.00 Sep. 16, 2009 Page 619 of 1036
REJ09B0414-0200