R0K561622S000BE Renesas Electronics America, R0K561622S000BE Datasheet - Page 705

• Manufacturer Part Number: R0K561622S000BE
• Description: KIT STARTER FOR H8SX/1622
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K561622S000BE

• Contents: Board, Cables, CD, Debugger, Power Supply
• Silicon Manufacturer: Renesas
• Features: Coding And Debugging, E10A Emulator, RS232 Serial Connection
• Kit Contents: Board
• Silicon Family Name: H8SX/1622F
• Silicon Core Number: R5F61622N50LGV
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: H8SX/1622
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

16.9
16.9.1
Operation of the SCI can be disabled or enabled using the module stop control register. The initial
setting is for operation of the SCI to be halted. Register access is enabled by clearing the module
stop state. For details, see section 24, Power-Down Modes.
16.9.2
When framing error detection is performed, a break can be detected by reading the RxD pin value
directly. In a break, the input from the RxD pin becomes all 0s, and so the FER flag is set, and the
PER flag may also be set. Note that, since the SCI continues the receive operation even after
receiving a break, even if the FER flag is cleared to 0, it will be set to 1 again.
16.9.3
When the TE bit is 0, the TxD pin is used as an I/O port whose direction (input or output) and
level are determined by DR and DDR. This can be used to set the TxD pin to mark state (high
level) or send a break during serial data transmission. To maintain the communication line in mark
state (the state of 1) until TE is set to 1, set both DDR and DR to 1. Since the TE bit is cleared to 0
at this point, the TxD pin becomes an I/O port, and 1 is output from the TxD pin. To send a break
during serial transmission, first set DDR to 1 and DR to 0, and then clear the TE bit to 0. When the
TE bit is cleared to 0, the transmitter is initialized regardless of the current transmission state, the
TxD pin becomes an I/O port, and 0 is output from the TxD pin.
16.9.4
Transmission cannot be started when a receive error flag (ORER, FER, or RER) is set to 1, even if
the TDRE flag is cleared to 0. Be sure to clear the receive error flags to 0 before starting
transmission. Note also that the receive error flags cannot be cleared to 0 even if the RE bit is
cleared to 0.
Usage Notes
Module Stop Function Setting
Break Detection and Processing
Mark State and Break Detection
Receive Error Flags and Transmit Operations (Clocked Synchronous Mode Only)
Section 16 Serial Communication Interface (SCI)
Rev. 2.00 Sep. 16, 2009 Page 675 of 1036
REJ09B0414-0200