PG-FP4-E Renesas Electronics America, PG-FP4-E Datasheet - Page 113

• Manufacturer Part Number: PG-FP4-E
• Description: PROGRAMMER FLASH MEMORY UNIV
• Manufacturer: Renesas Electronics America

Specifications of PG-FP4-E

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

10.3 GUI Software Error Messages
E200
E201
E202
E203
E204
E205
E206
E207
E208
E209
In addition to the error messages listed below, error messages can be displayed directly from the PG-FP4.
No.
Opening script file failed.
Updating the firmware will take several minutes.
ATTENTION:
• The process of updating your firmware
• Without firmware this FP4
Install new firmware in your programmer?
Checking address data failed.
Evaluating area data failed.
Unknown Version of your firmware!
The FP4 GUI may not work properly!
The firmware you are using
requires an update of the GUI!
The FP4 GUI may not work properly!
Your firmware is not up to date!
Updating the firmware will take several minutes.
ATTENTION:
- The process of updating your firmware must NOT
- Without new firmware this FP4 GUI will NOT run
Install new firmware in your programmer?
Wrong firmware in programmer!
The GUI may not work properly!
The programmer memory does not contain the
most recent downloaded file (different CRC).
Please download your user application(s) again.
Searching for a port communicating with the
programmer failed.
Please check the connection.
be interrupted!
properly.
must NOT be interrupted!
GUI will NOT run properly.
Message
CHAPTER 10 ERROR MESSAGES
User’s Manual U15260EJ4V0UM
Signature command returned unexpected character.
Signature command returned unexpected character.
Opening the specified script file failed. Script file in use?
Check if the [ Update Firmware ] menu has been started.
Refer to 3.2.1 Firmware update installation for a
description of these messages.
Before issuing an EPV command, the GUI software verifies
proper application file contents by verifying the actual CRC
with the one saved after file download to FP4.ini.
No communication with the programmer could be
established at all. Sequence of connecting the PG-FP4 on
start up of the GUI software:
1. Read most recent INI-file settings. Try opening the
2. If 1. fails, try the following twice:
3. When serial communication is established and most
most recent PC port and send the ver command to
the PG.
a) Open the USB port and send the ver command
b) Open COM1 … COM6 with all possible baud rates
recently the parallel download port has been used
(DownloadPort-key in INI-file):
Try opening the parallel PC port and send the ctr on
command to the PG
(on Windows 98 and Windows 2000 only).
and send the ver command for each of these
combinations.
As soon as any of the combinations above
succeeds the communication port has been found.
Description
111