PG-FP4-E Renesas Electronics America, PG-FP4-E Datasheet - Page 116

• Manufacturer Part Number: PG-FP4-E
• Description: PROGRAMMER FLASH MEMORY UNIV
• Manufacturer: Renesas Electronics America

Specifications of PG-FP4-E

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

10.4 GUI Software Information Messages
message is sent as information only and does not require any user action in response.
114
I200
I201
I202
I300
I301
I500
I501
I502
I801
I800
I802
I804
I805
I905
I906
I907
I911
I912
I913
I914
Informational messages do not need any workaround because they do not indicate an error condition. The
No.
New firmware installed successfully in your
programmer!
Opening parallel download port failed.
File download will be done on the serial port.
Download via parallel port failed.
Value out of range.
Multiple Program Areas are disabled.
Please enable Program Areas usage in the Device
Setup Dialog.
Operation completed successfully.
This command can only be used for UC2 devices.
Note:
To abort a write, erase or verify operation it is
necessary to reset the programmer manually.
End record not found, created.
Buffer is modified.
Are you sure to close ?
The file is modified.
Save ?
The file is modified.
Are you sure to quit?
This file is not valid.
*.set is not valid. Using most recent settings.
*.prm is not valid. Using most recent settings.
Caution: When 'Chip Erase' is disabled, chip
cannot be erased and programmed any more!
The selection is out of range.
The selection is out of range.
Value is out of range.
Value is out of range.
Message
CHAPTER 10 ERROR MESSAGES
User’s Manual U15260EJ4V0UM
Firmware upgrade completed with success.
The Windows internal function to open the parallel port
failed (port occupied by other software?)
Communication via the parallel port failed. Re-download or
use a serial port.
The value entered in a dialog box is out of the allowable
max/min range. The max/min value or the most recent
value will be written into the dialog element.
The menu command [Programmer] → [Select
Programming area] can only be used when it has been
enabled on the Advanced tab of the device Setup dialog
box.
Executing a command succeeded.
The menu entries Device → Write Security and Device
Checksum can only be used for UC2 devices.
Aborting device-related commands requires an additional
Programmer reset.
The HEX Editor implicitly created an end record when
loading a file.
The HEX Editor indicates that its contents are not yet
saved to a disk.
The HEX Editor is attempting to open an invalid file.
The SET file format is old.
The PRM file format is old.
This is displayed when [Disable Chip Erase] on Advanced
tab of the [Device] → [Setup] menu is checked.
The value of [Speed] on the Standard tab of the [Device] →
[Setup] menu exceeds the maximum value.
The value of [Speed] on the Standard tab of the [Device]
→ [Setup] menu is smaller than the minimum value.
The value of [Frequency] on the Standard tab of the
[Device] → [Setup] menu exceeds the maximum value.
The value of [Frequency] on the Standard tab of the
[Device] → [Setup] menu is smaller than the minimum
value.
Description