PG-FP4-E Renesas Electronics America, PG-FP4-E Datasheet - Page 54

no-image

PG-FP4-E

Manufacturer Part Number
PG-FP4-E
Description
PROGRAMMER FLASH MEMORY UNIV
Manufacturer
Renesas Electronics America
Datasheet

Specifications of PG-FP4-E

Lead Free Status / RoHS Status
Lead free / RoHS Compliant
52
(8) [Autoprocedure [EPV]] menu
(9) [Signature read] menu
(10) [Get Security Settings] menu
same, it sequentially executes the Erase and Program commands explained above.
When the Program command is executed, whether the write level is secured is verified after the program has
been written. Note, however, that this verification does not detect a communication error of the user program
that is transmitted from the PG-FP4 to the target device.
To transmit the memory contents of the PG-FP4 to the target device to compare them with the data written to
the flash memory of the target device because a communication error of the user program was detected,
specify automatic execution of the Verify command after execution of the Program command, by using the
Command options on the Advanced tab of the [Device] > [Setup…] menu.
During EVP, the progress is displayed in the communication log window, indicating the operation of the
programmer. For the selected command, and its execution operation and message, refer to CHAPTER 5
SAMPLE PROGRAMMING SESSION USING GUI SOFTWARE.
You may abort the EPV procedure by pressing the Cancel button on the PG-FP4.
After completing the EPV command, the GUI software displays the target device command execution result.
The Signature Read command is used to read the signature information of the target device (such as the
device name and flash memory information).
The [Get Security Settings] menu is used to read information on the security flag or boot area setting of the
target device connected to the PG-FP4, and reflect the result in the Advanced Setup menu.
When this menu is specifiable, be sure to confirm the security status and the boot area by executing the Get
Security Settings menu before executing a security command, and then add the security specification.
Caution The Checksum command is available only when using a single-power-supply flash memory
The EPV command compares the checksum value when the user program is downloaded with the
checksum value in the user program area of the PG-FP4 subject to EPV. If the two values are the
microcontroller or two-power-supply flash memory microcontroller that supports the
Checksum command.
CHAPTER 4 PG-FP4 OPERATION USING GUI SOFTWARE
User’s Manual U15260EJ4V0UM

Related parts for PG-FP4-E