MCB2100+U NXP Semiconductors, MCB2100+U Datasheet - Page 11

• Manufacturer Part Number: MCB2100+U
• Description: BOARD EVAL/ULINK JTAG LPC210XARM
• Manufacturer: NXP Semiconductors
• Series: Keilr
• Type: ARM7 Processor, Microcontrollerr

Specifications of MCB2100+U

• Contents: Evaluation Board, ULINK JTAG, Debugger and Software
• For Use With/related Products: LPC2114,2119,2124,2129,2194
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 568-1755; OM10046

NXP Semiconductors
AN10302_4
Application note
Fig 7. IAR/Philips LPC210x Kickstart card.
JTAG port — Connection to JTAG emulator (e.g. JLink). This is a standard JTAG port as
outlined in ARM documentation.
ETM (Embedded Trace Macrocell) port — Provides interface to emulators with trace
capability.
P0 and P1, UARTs — Access to UART0 and UART1.
RESET — Microcontroller reset.
Interrupt0 — This button provides a source for interrupt zero.
Interrupt1 — This button pulls the P0.14 pin of the microcontroller LOW, providing either
an external interrupt or manual entry into ISP mode.
Interrupt2 — This button provides a source for interrupt two.
LED jumper block — enables/disables individual LEDs.
LEDs — buffered with a LVT16244.
Rev. 04 — 12 October 2006
Using the Philips LPC2000 Flash utility
AN10302
© NXP B.V. 2006. All rights reserved.
11 of 14