EVAL6730 STMicroelectronics, EVAL6730 Datasheet - Page 16

• Manufacturer Part Number: EVAL6730
• Description: EVAL BOARD FOR L6730XX
• Manufacturer: STMicroelectronics
• Type: Motor / Motion Controllers & Driversr

Specifications of EVAL6730

• Main Purpose: DC/DC, Step Down
• Outputs And Type: 1, Non-Isolated
• Power - Output: 66W
• Voltage - Output: 3.3V
• Current - Output: 20A
• Voltage - Input: 4.5 ~ 14V
• Regulator Topology: Buck
• Frequency - Switching: 400kHz
• Board Type: Fully Populated
• Utilized Ic / Part: L6730
• Input Voltage: 8 V to 52 V
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: L6208
• Other names: 497-5501

Device description
5.4
16/52
Figure 6.
Internal and external references
It is possible to set two internal references, 0.6 V and 1.2 V, or provide an external reference
from 0 V to 2.5 V. The maximum value of the external reference depends on the V
V
maximum external reference is 2.5 V (typ).
●
●
●
Providing an external reference from 0V to 450 mV the output voltage will be regulated but
some restrictions must be considered:
●
●
●
To set the resistor divider it must be considered that a 100 kΩ pull-down resistor is
integrated into the device (see
voltage at the EAREF pin is captured by the device at the start-up when Vcc is about 4 V.
CC
= 4 V the clamp operates at about 2 V (typ.), while with V
V
V
V
The minimum OVP threshold is set at 300 mV.
The under-voltage-protection doesn’t work.
The PGOOD signal remains low.
EAREF
EAREF
EAREF
Bypassing the LDO
from 80% to 95% of V
from 95% to 100% of V
from 0% to 80% of V
Doc ID 11938 Rev 3
Figure
CCDR
CCDR
CCDR
7.). Finally it must be taken into account that the
−> External reference
−> V
−> V
REF
REF
= 1.2 V
= 0.6 V
CC
greater than 5 V the
L6730 - L6730B
CC
: with