M68ICS08KX Freescale Semiconductor, M68ICS08KX Datasheet - Page 50

• Manufacturer Part Number: M68ICS08KX
• Description: SIM PROGRAM FOR 68HC908KX8/KX2
• Manufacturer: Freescale Semiconductor
• Type: Simulator/Programmerr

Specifications of M68ICS08KX

• Contents: Programmer, Power Supply, Assembler/Simulator/Debugger, Cable, Software and Documentation
• For Use With/related Products: 68HC908KX8/KX2
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

4.1 Introduction
4.2 Target System Header Placement and Layout
M68ICS08KX In-Circuit Simulator
MOTOROLA
User’s Manual — M68ICS08KX In-Circuit Simulator
No.
Pin
1
2
3
4
5
6
7
M68ICS08KX8
TGT-PTA0
RST-OUT
TGT-IRQ
RST-IN
Label
GND
RST
IRQ
Table 4-1. MON08 Target System Connector J3
The MON08 debugging interface may be used to debug and program a target
system’s MCU directly. The target system must be connected to the
M68ICS08KX in-circuit simulator board’s MON08 interface connector. This
section explains how to connect to the MON08 interface on the target board.
Two headers must be placed on the target board:
Table 4-1 shows the target-system interconnections for J3.
In from target
In from target
Out to target
Out to target
Bidirectional
Bidirectional
Direction
•
•
Ground
P1 — 16-pin header such as Berg Electronics part number 67997-616
P2 — 1-pin header such as Berg Electronics part number 68001-601
Section 4. Using the MON08 Interface
Using the MON08 Interface
Connect to logic that is to receive the RST signal.
Connect to common (V
Connect to all logic that generates resets.
Connect to MCU RST pin and P1 pin 1. No other target-system
logic should be tied to this signal. It will swing from 0 to +5 Vdc.
Connect to logic that generates interrupts.
Connect to MCU IRQ pin. No other target-system logic should be
tied to this signal. It will swing from 0 to +8.6 Vdc.
Connect to user circuit that would normally be connected to PTA0
on the MCU. This circuit will not be connected to the MCU when
the in-circuit simulator is being used.
Target System Connection
SS
).
User’s Manual
45