MAX4542 Maxim, MAX4542 Datasheet
MAX4542
Available stocks
Related parts for MAX4542
MAX4542 Summary of contents
Page 1
... The MAX4541/MAX4542/MAX4543 are dual single-pole/ single-throw (SPST) devices and the MAX4544 is a single- pole/double-throw (SPDT) device. The MAX4541 has two normally open (NO) switches and the MAX4542 has two normally closed (NC) switches. The MAX4543 has one NO and one NC switch and can be used as an SPDT, while the MAX4544 is an SPDT ...
Page 2
... SOT23-6 (derate 7.1mW/°C above +70°C)....................571mW SOT23-8 (derate 5.3mW/°C above +70°C)....................421mW Note 1: Signals on NC_, NO_, COM_, or IN_ exceeding are clamped by internal diodes. Limit forward diode current to maximum current rating. Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied ...
Page 3
... Figure 50Ω 5pF 1MHz Figure 1MHz +25°C, Figure 1MHz +25°C, Figure 7 A MAX4541/MAX4542 1MHz +25°C, A MAX4543 Figure 7 MAX4544 V+ = 5.5V V+, all channels on or off IN MIN TYP MAX MAX ...
Page 4
... Note 6: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the specified analog signal range. Note 7: Leakage parameters are 100% tested at maximum rated hot temperature and guaranteed by correlation at +25°C. Note 8: Off-isolation = 20 x log [V 10 COM Note 9: Between the two switches, MAX4541/MAX4542/MAX4543 only. 4 _______________________________________________________________________________________ = 0.8V unless otherwise noted.) (Notes 2, 3) ...
Page 5
Operating Characteristics (T = +25°C, unless otherwise noted.) A ON-RESISTANCE vs. COM_ VOLTAGE + + +12V ...
Page 6
... Low-Voltage, Single-Supply Dual SPST/SPDT Analog Switches MAX4541 MAX4542 DIP/SO/ DIP/SO/ SOT23-8 SOT23-8 µMAX/ µMAX/ TDFN TDFN 1 1 — — — — — — — — — ...
Page 7
... V+ (for D1), and to a diode drop above ground (for D2). Leakage is unaffected by adding the diodes. On-resistance increases by a small amount at low supply voltages. Maximum supply voltage (V+) must not exceed 13V. MAX4541 MAX4542 MAX4543 MAX4544 SWITCH INPUT ...
Page 8
... INCLUDES FIXTURE AND STRAY CAPACITANCE. L Figure 3a. Break-Before-Make Interval (MAX4543 Only) V+ MAX4544 V+ NC +3V COM NO IN LOGIC GND INPUT C INCLUDES FIXTURE AND STRAY CAPACITANCE. L Figure 3b. Break-Before-Make Interval (MAX4544 Only) MAX4541 MAX4542 MAX4543 R GEN MAX4544 GEN GND IN_ Figure 4. Charge Injection 8 _______________________________________________________________________________________ V OUT1 V OUT2 C ...
Page 9
... Figure 7. Channel Off/On-Capacitance _______________________________________________________________________________________ Low-Voltage, Single-Supply Dual SPST/SPDT Analog Switches MAX4541 MAX4542 MAX4543 MAX4544 SIGNAL GENERATOR 0dBm 0V OR 2.4V IN ANALYZER Figure 6. Crosstalk MAX4541 MAX4542 MAX4543 MAX4544 2.4V MAX4541 V+ 10nF MAX4542 MAX4543 V+ COM1 NO1 IN2 IN1 0 OR 2.4V COM2 NO2 GND R L 50Ω 2. ...
Page 10
... Plastic DIP MAX4542C/D 0°C to +70°C Dice* MAX4542EKA-T -40°C to +85°C 8 SOT23-8 MAX4542ETA -40°C to +85°C 8 TDFN-EP** MAX4542EUA -40°C to +85°C 8 µMAX MAX4542ESA -40°C to +85° MAX4542EPA -40°C to +85°C 8 Plastic DIP MAX4543CUA 0°C to +70°C 8 µMAX MAX4543CSA 0° ...
Page 11
... Low-Voltage, Single-Supply Dual SPST/SPDT Analog Switches MAX4542 8 NC1 IN1 COM1 2 6 COM2 IN2 3 GND 4 5 NO2 μMAX/SO/DIP/TDFN MAX4542 8 1 NC1 COM1 7 IN1 IN2 GND 3 5 COM2 4 NO2 SOT23-8 SWITCHES SHOWN FOR LOGIC "0" INPUT MAX4543 8 NO1 ...
Page 12
... Low-Voltage, Single-Supply Dual SPST/SPDT Analog Switches (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information go to www.maxim-ic.com/packages.) 12 ______________________________________________________________________________________ Package Information ...
Page 13
... For the latest package outline information go to www.maxim-ic.com/packages.) COMMON DIMENSIONS SYMBOL MIN. MAX. A 0.70 0.80 D 2.90 3.10 E 2.90 3.10 A1 0.00 0.05 L 0.20 0.40 k 0.25 MIN. A2 0.20 REF. ______________________________________________________________________________________ Low-Voltage, Single-Supply Dual SPST/SPDT Analog Switches Package Information (continued) PACKAGE VARIATIONS PKG ...
Page 14
... Low-Voltage, Single-Supply Dual SPST/SPDT Analog Switches (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information go to www.maxim-ic.com/packages.) 14 ______________________________________________________________________________________ Package Information (continued) PACKAGE OUTLINE, SOT 6L BODY 21-0058 ...
Page 15
... For the latest package outline information go to www.maxim-ic.com/packages.) ______________________________________________________________________________________ Low-Voltage, Single-Supply Dual SPST/SPDT Analog Switches Package Information (continued) PACKAGE OUTLINE, SOT 6L BODY 2 21-0058 ...
Page 16
... Revision History Pages changed at Rev 4: 1–16 Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. ...