MAX4620 Maxim, MAX4620 Datasheet
MAX4620
Available stocks
Related parts for MAX4620
MAX4620 Summary of contents
Page 1
... The on-resistance is 70Ω max, matched between switches to 0.5Ω (typ), and flat (2Ω typ) over the specified signal range. The MAX4620 has four NO switches, the MAX4630 has four NC switches, and the MAX4640 has two NO and two NC switches. These devices are available in 14-pin TSSOP, SO, and DIP packages ...
Page 2
... V+, GND, IN_, COM_ ....................................................±2.5kV NO_, NC_ .......................................................................±15kV Note 1: Signals on NO_, NC_, COM_, or IN_ exceeding V+ or GND are clamped by internal diodes. Limit forward current to maximum current rating. Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied ...
Page 3
ESD-Protected, Low-Voltage, Quad, ELECTRICAL CHARACTERISTICS—SINGLE +5V SUPPLY (continued) (V+ = +4.5V to +5.5V 2.4V 0.8V +25°C.) (Note 2) A PARAMETER SYMBOL ANALOG SWITCH COM_ Off-Leakage Current I COM_(OFF) (Note 5) ...
Page 4
ESD-Protected, Low-Voltage, Quad, SPST, CMOS Analog Switches ELECTRICAL CHARACTERISTICS—SINGLE +5V SUPPLY (continued) (V+ = +4.5V to +5.5V 2.4V 0.8V +25°C.) (Note 2) A PARAMETER SYMBOL Crosstalk (Note ...
Page 5
... ESD SCR ent ESD SCR Holding Voltage V POWER SUPPLY Power-Supply Range V+ Positive Supply Current Note 2: The algebraic convention, where the most negative value is a minimum and the most positive value is a maximum, is used in this data sheet. Note 3: ∆ ...
Page 6
ESD-Protected, Low-Voltage, Quad, SPST, CMOS Analog Switches (V+ = +5V +25°C, unless otherwise specified.) A ON-RESISTANCE vs. V AND COM SUPPLY VOLTAGE 180 160 V+ = 1.8V 140 120 V+ = 2.5V 100 V+ = 3.3V V+ ...
Page 7
... ESD-Protected, Low-Voltage, Quad, (V+ = +5V +25°C, unless otherwise specified.) A FREQUENCY RESPONSE 20 0 -20 ON-LOSS -40 OFF -60 -80 -100 -120 0.01 0.1 1 FREQUENCY (MHz) PIN MAX4620 MAX4630 MAX4640 1 — — — — — — — ...
Page 8
... L L 300Ω 35pF SWITCH 0 OUTPUT MAX4620 MAX4630 MAX4640 CAPACITANCE METER f = 1MHz Figure 3. Channel Off/On-Capacitance t < 20ns R t < 20ns F 50% t OFF V OUT 0 0 OUT 0UT t ON MAX4620 V+ MAX4630 10nF MAX4640 V+ COM_ NO_/NC_ GND ...
Page 9
... Proper power-supply sequencing is recommended for all CMOS devices. Always sequence V+ on first, fol- lowed by the logic inputs, NO/NC, or COM. The MAX4620/MAX4630/MAX4640 are capable of +12V single-supply operation with some precautions. The absolute maximum rating for V+ is 13V (referenced to GND). When operating near this region, bypass V+ with a minimum 0.1µ ...
Page 10
... The IEC 1000-4-2 standard covers ESD testing and performance of finished equipment; it does not specifi- cally refer to ICs. The MAX4620/MAX4630/MAX4640 enable the design of equipment that meets Level 4 (the highest level) of IEC 1000-4-2, without additional ESD protection components. ...
Page 11
ESD-Protected, Low-Voltage, Quad 1MΩ 1500Ω DISCHARGE CHARGE-CURRENT RESISTANCE LIMIT RESISTOR HIGH STORAGE VOLTAGE 100pF CAPACITOR DC SOURCE Figure 6. Human Body ESD Test Model 50MΩ to 100MΩ 330Ω DISCHARGE ...
Page 12
ESD-Protected, Low-Voltage, Quad, SPST, CMOS Analog Switches Pin Configurations/Functional Diagrams/Truth Tables (continued) TOP VIEW MAX4630 1 NC1 COM1 2 NC2 3 COM2 4 5 IN2 IN3 6 GND 7 TSSOP/SO/DIP INPUT SWITCH STATE LOW HIGH Ordering Information (continued) PART ...
Page 13
ESD-Protected, Low-Voltage, Quad, SPST, CMOS Analog Switches ______________________________________________________________________________________ Package Information 13 ...
Page 14
ESD-Protected, Low-Voltage, Quad, SPST, CMOS Analog Switches 14 ______________________________________________________________________________________ Package Information (continued) ...
Page 15
ESD-Protected, Low-Voltage, Quad, SPST, CMOS Analog Switches ______________________________________________________________________________________ Package Information (continued) 15 ...
Page 16
... SPST, CMOS Analog Switches Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied ...