NH82801GBM SL8YB Intel Corporation, NH82801GBM SL8YB Datasheet - Page 154

no-image

NH82801GBM SL8YB

Manufacturer Part Number
NH82801GBM SL8YB
Description
Manufacturer
Intel Corporation
Datasheet

Specifications of NH82801GBM SL8YB

Case
BGA
Date_code
07+
Table 5-25. General Power States for Systems Using Intel
State/
Substates
Stop-Clock: The STPCLK# signal goes active to the processor. The processor
performs a Stop-Grant cycle, halts its instruction stream. ICH7 then asserts
G0/S0/C3
DPSLP# followed by STP_CPU#, which forces the clock generator to stop the
(Mobile/Ultra
processor clock. This is also used for Intel SpeedStep
Mobile Only)
Accesses to memory (by graphics, PCI, or internal units) is not permitted while in
a C3 state.
Stop-Clock with Lower Processor Voltage: This closely resembles the G0/
G0/S0/C4
S0/C3 state. However, after the ICH7 has asserted STP_CPU#, it then lowers the
(Mobile/Ultra
voltage to the processor. This reduces the leakage on the processor. Prior to
Mobile Only)
exiting the C4 state, the ICH7 increases the voltage to the processor.
Stop-Grant: Similar to G0/S0/C2 state. ICH7 also has the option to assert the
CPUSLP# signal to further reduce processor power consumption (Desktop only).
G1/S1
Note: The behavior for this state is slightly different when supporting iA64
processors.
Suspend-To-RAM (STR): The system context is maintained in system DRAM,
G1/S3
but power is shut off to non-critical circuits. Memory is retained, and refreshes
continue. All clocks stop except RTC clock.
Suspend-To-Disk (STD): The context of the system is maintained on the disk.
G1/S4
All power is then shut off to the system except for the logic required to resume.
Soft Off (SOFF): System context is not maintained. All power is shut off except
G2/S5
for the logic required to restart. A full boot is required when waking.
Mechanical OFF (MOFF): System context not maintained. All power is shut off
except for the RTC. No “Wake” events are possible, because the system does not
have any power. This state occurs if the user removes the batteries, turns off a
G3
mechanical switch, or if the system power supply is at a level that is insufficient
to power the “waking” logic. When system power returns, transition will depends
on the state just prior to the entry to G3 and the AFTERG3 bit in the
GEN_PMCON3 register (D31:F0, offset A4). Refer to
Table 5-26
shows the transitions rules among the various states. Note that transitions
among the various states may appear to temporarily transition through intermediate
states. For example, in going from S0 to S1, it may appear to pass through the G0/S0/
C2 states. These intermediate transitions and states are not listed in the table.
154
Functional Description
®
ICH7 (Sheet 2 of 2)
Legacy Name / Description
®
technology support.
Table 5-33
®
Intel
ICH7 Family Datasheet
for more details.

Related parts for NH82801GBM SL8YB