5KP30A-E3/54 Vishay, 5KP30A-E3/54 Datasheet - Page 5

• Manufacturer Part Number: 5KP30A-E3/54
• Description: TVS 5KW UNIDIR 30V 5% P600
• Manufacturer: Vishay
• Series: TransZorb®r

Specifications of 5KP30A-E3/54

• Voltage - Reverse Standoff (typ): 30V
• Voltage - Breakdown: 33.3V
• Power (watts): 5000W
• Polarization: Unidirectional
• Mounting Type: Through Hole
• Package / Case: P600, Axial
• Polarity: Unidirectional
• Channels: 1 Channel
• Clamping Voltage: 48.4 V
• Operating Voltage: 30 V
• Breakdown Voltage: 33.3 V to 36.8 V
• Termination Style: Axial
• Peak Surge Current: 103 A
• Peak Pulse Power Dissipation: 5000 W
• Maximum Operating Temperature: + 175 C
• Minimum Operating Temperature: - 55 C
• Dimensions: 9.1 mm Dia. x 9.1 (Max) mm W x 9.1 mm L
• Reverse Stand-off Voltage Vrwm: 30V
• Breakdown Voltage Range: 33.3V To 36.8V
• Clamping Voltage Vc Max: 48.4V
• Diode Configuration: Unidirectional
• Peak Pulse Current Ippm: 103A
• Diode Case Style: P600
• No. Of: RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

5KP5.0 thru 5KP188A
Vishay General Semiconductor
PACKAGE OUTLINE DIMENSIONS in inches (millimeters)
APPLICATION NOTE
The 5KP series of high power transient voltage
suppressors were designed to be used on the output
of switching power supplies. These devices may be
used to replace crowbar circuits. Both the 5 % and
10 % voltage tolerances are referenced to the power
supply output voltage level.
www.vishay.com
5
8
6
4
2
0
0
L = 0.375" (9.5 mm)
Lead Lengths
25
Figure 5. Power Derating Curve
50
T
L
- Lead Temperature (°C)
75
[e-mail], [e-mail], [e-mail]
100
For technical questions within your region, please contact one of the following:
125
60 Hz
Resistive or
Inductive Load
150
175
0.360 (9.1)
0.340 (8.6)
200
0.052 (1.32)
0.048 (1.22)
DIA.
Case Style P600
They are able to withstand high levels of peak current
while allowing a circuit breaker to trip or a fuse blow
before shorting. This will enable the user to reset the
breaker or replace the fuse and continue operation.
For this type operation, it is recommended that a
sufficient mounting surface be used for dissipating the
heat generated by the Transient Voltage Suppressor
during the transient or over-voltage condition.
0.360 (9.1)
0.340 (8.6)
1.0 (25.4)
1.0 (25.4)
Figure 6. Maximum Non-repetitive Forward Surge Current
MIN.
MIN.
500
450
400
350
300
250
200
1
Number of Cycles at 60 Hz
8.3 ms Single Half Sine-Wave
10
Document Number: 88308
Revision: 21-Oct-08
100