C112 13D004 000 02 Amphenol-Tuchel Electronics, C112 13D004 000 02 Datasheet - Page 4

• Manufacturer Part Number: C112 13D004 000 02
• Description: CONN RT ANG FEMALE 4POS
• Manufacturer: Amphenol-Tuchel Electronics
• Series: C112r

Specifications of C112 13D004 000 02

• Connector Type: Plug, Female Sockets
• Number Of Positions: 4
• Mounting Type: Free Hanging (In-Line), Right Angle
• Termination: Screw
• Fastening Type: Threaded
• Ingress Protection: IP65/67 - Dust Tight, Water Resistant
• Shell Material, Finish: Polyamide
• For Use With: 480-2823 - SENSOR HALL EFFECT DIFF SPEED480-2821 - SENSOR HALL EFFECT DIFF SPEED480-2812 - SENSOR SST 5/8" HALL EFFECT480-2810 - SENSOR SST 12MM ZERO SPEEDCH711 - SENSOR HALL EFFECT M18 ST STEELCH704 - SENSOR SPEED HALL EFFECT M12
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Orientation: -
• Shell Size - Insert: -
• Shell Size, Military: -

4
Termination
Application
Assembly
and use
Connectors should be used according to their
rated performance values. These rated values
are etablished under specific conditions to meet
product specifications or other electrical
qualifications. The C112 connectors are designed
for use in a variety of electrical equipment and
applications that control various appliances or
link communications with sensor technology.
The housings of the panel receptacle or plug
must be reliably integrated into the protective
means of the enclosure. Reference: DIN VDE
0100 part 410; 80384-4-41. During assembly,
Customer assembled cable connectors must follow
precise instructions to properly secure the strain
relief system. There is an integrated strain relief
clamp or a standard Pg cable entry. The standard
Pg cable entry requires a strain relief close to the
rear of the connector. Cable selection should
The user is responsible to verify that the connector
meets the application requirements of the product.
All connector rating data in this catalog is based on
the overvoltage of category III and pollution degree
of 2/3 for electrical devices. All specifications are
met when the connectors are completely mated.
care must be given to ensure that all components
are correctly mounted and screw terminations
are tightened to the correct torque.
meet the same specifications as the connector
(i.e., solvent resistance or fire protection). Correct
polarity must be observed when terminating
wires. The wire insulation should be stripped to
the proper length and wire diameter.