PG0200.601NL PULSE ELECTRONICS CORPORATION, PG0200.601NL Datasheet - Page 2

• Manufacturer Part Number: PG0200.601NL
• Description: INDUCTOR PWR CUBE 0.57UH T/H
• Manufacturer: PULSE ELECTRONICS CORPORATION
• Series: PG0200NLr

Specifications of PG0200.601NL

• Inductance: 600nH
• Current: 29A
• Current - Saturation: 45A
• Current - Temperature Rise: 29A
• Tolerance: ±15%
• Dc Resistance (dcr): 1.450 mOhm Max
• Package / Case: Radial
• Mounting Type: Through Hole
• Operating Temperature: -40°C ~ 125°C
• Frequency - Test: 100kHz
• Applications: General Purpose
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Shielding: -
• Q @ Freq: -
• Self Resonant Freq: -

Notes from Tables
1. The temperature of the component (ambient plus temperature
2. Inductance at Irated is a typical inductance value for the
3. The rated current listed is the lower of the saturation current @
4. The saturation current, Isat, is the current at which the
5. The heating current, I
THT POWER INDUCTORS
Power Cube Inductors - PG0200NL Series
www.pulseeng.com
USA 858 674 8100
rise) must be within the specified operating temperature range.
component taken at rated current.
25°C or the heating current.
component inductance drops by 15% (typical) at an ambient
temperature of 25°C. This current is determined by placing the
component in the specified ambient environment and applying a
short duration pulse current (to eliminate self-heating effects) to
the component.
the component temperature by approximately 40°C. The heating
current is determined by mounting the component on a typical
PCB and applying current for 30 minutes. The temperature is
measured by placing the thermocouple on top of the unit under
test. Take note that the component’s performance varies
depending on the system condition. It is suggested that the
• •
Germany 49 7032 7806 0
Typical Inductance vs DC Bias Current Characteristics
DC
, is the DC current required to raise
• •
Singapore 65 6287 8998
• •
86
Shanghai
6. Core loss approximation is based on published core data:
7. Unless otherwise specified, all testing is made at 100kHz, 0.1V
8. The "NL" suffix indicates an RoHS-compliant part number. Non-
NL suffixed parts are not necessarily RoHS compliant, but are
electrically and mechanically equivalent to NL versions. If a part
number does not have the "NL" suffix, but an RoHS compliant
version is required, please contact Pulse for availability.
component be tested at the system level, to verify the
temperature rise of the component during system operation.
86 21 54643211 / 2
Core Loss = K1 * (f)
Where: Core Loss = in Watts
f = switching frequency in kHz
K1 & K2 = core loss factors
Δ Δ I = delta I across the component in Ampere
K2Δ Δ I = one half of the peak to peak flux density
across the component in Gauss
• •
China 86 755 33966678
1.26
* (K2ΔI)
2.11
• •
SPM2007 (11/07)
Taiwan 886 3 4641811
AC
.