PIC16C63-10/SP Microchip Technology, PIC16C63-10/SP Datasheet - Page 308

• Manufacturer Part Number: PIC16C63-10/SP
• Description: IC MCU OTP 4KX14 PWM 28DIP
• Manufacturer: Microchip Technology
• Series: PIC® 16Cr

Specifications of PIC16C63-10/SP

• Core Size: 8-Bit
• Program Memory Size: 7KB (4K x 14)
• Oscillator Type: External
• Core Processor: PIC
• Speed: 10MHz
• Connectivity: I²C, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 22
• Program Memory Type: OTP
• Ram Size: 192 x 8
• Voltage - Supply (vcc/vdd): 4 V ~ 6 V
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 28-DIP (0.300", 7.62mm)
• Controller Family/series: PIC16C
• No. Of I/o's: 22
• Ram Memory Size: 192Byte
• Cpu Speed: 20MHz
• No. Of Timers: 3
• No. Of Pwm: RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: DVMCPA - KIT DVR BOARD EVAL SYSTEM MXDEV1
• Eeprom Size: -
• Data Converters: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PIC16C6X
APPENDIX C: WHAT’S NEW
Added PIC16CR63 and PIC16CR65 devices.
Added PIC16C66 and PIC16C67 devices. The
PIC16C66/67 devices have 368 bytes of data memory
distributed in 4 banks and 8K of program memory in 4
pages. These two devices have an enhanced SPI that
supports both clock phase and polarity. The USART
has been enhanced.
When upgrading to the PIC16C66/67 please note that
the upper 16 bytes of data memory in banks 1,2, and 3
are mapped into bank 0. This may require relocation of
data memory usage in the user application code.
Q-cycles for instruction execution were added to Sec-
tion 14.0 Instruction Set Summary.
DS30234D-page 308
APPENDIX D: WHAT’S CHANGED
Minor changes, spelling and grammatical changes.
Divided SPI section into SPI for the PIC16C66/67
(Section 11.3)
(Section 11.2).
Added the following note for the USART. This applies to
all devices except the PIC16C66 and PIC16C67.
For the PIC16C63/R63/65/65A/R65 the asynchronous
high speed mode (BRGH = 1) may experience a high
rate of receive errors. It is recommended that BRGH =
0. If you desire a higher baud rate than BRGH = 0 can
support, refer to the device errata for additional infor-
mation or use the PIC16C66/67.
and
SPI
1997 Microchip Technology Inc.
for
all
other
devices