MC9RS08KA2CPC Freescale Semiconductor, MC9RS08KA2CPC Datasheet - Page 32

• Manufacturer Part Number: MC9RS08KA2CPC
• Description: IC MCU 8-BIT 2K FLASH 8-PDIP
• Manufacturer: Freescale Semiconductor
• Series: RS08r

Specifications of MC9RS08KA2CPC

• Core Processor: RS08
• Core Size: 8-Bit
• Speed: 10MHz
• Peripherals: LVD, POR, WDT
• Number Of I /o: 4
• Program Memory Size: 2KB (2K x 8)
• Program Memory Type: FLASH
• Ram Size: 63 x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-DIP (0.300", 7.62mm)
• Processor Series: RS08KA
• Core: RS08
• Data Bus Width: 8 bit
• Data Ram Size: 63 B
• Maximum Clock Frequency: 20 MHz
• Number Of Programmable I/os: 4
• Operating Supply Voltage: 2.7 V to 5.5 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: Through Hole
• Development Tools By Supplier: DEMO9RS08KA8, DEMO9RS08KA2
• Minimum Operating Temperature: - 40 C
• For Use With: DEMO9RS08KA2 - DEMO BOARD FOR 9RS08KA2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -
• Connectivity: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Chapter 4 Memory
4.7
The Flash module has a nonvolatile register, NVOPT ($3FFC), in Flash memory which is copied into the
corresponding control register, FOPT ($0210), at reset.
4.7.1
During reset, the contents of the nonvolatile location NVOPT is copied from Flash into FOPT. Bits 7
through 1 are not used and always read 0. This register may be read at any time, but writes have no meaning
or effect. To change the value in this register, erase and reprogram the NVOPT location in Flash memory
as usual and then issue a new MCU reset.
32
SECD
Field
0
Reset
W
Flash Registers and Control Bits
R
Flash Options Register (FOPT and NVOPT)
Security State Code — This bit field determines the security state of the MCU. When the MCU is secured, the
contents of Flash memory cannot be accessed by instructions from any unsecured source including the
background debug interface; refer to
0 Security engaged.
1 Security disengaged.
When the device boots up to normal operating mode, where MS pin is high
during reset, with SECD programmed (SECD = 0), Flash security is
engaged. BKGDPE is reset to 0, and all BDM communication is blocked,
and background debug is not allowed.
0
7
= Unimplemented or Reserved
6
0
This register is loaded from nonvolatile location NVOPT during reset.
Figure 4-3. Flash Options Register (FOPT)
MC9RS08KA2 Series Data Sheet, Rev. 4
Table 4-2. FOPT Field Descriptions
0
5
Section 4.6.4,
NOTE
4
0
Description
“Security”.
0
3
2
0
Freescale Semiconductor
0
1
SECD
0