AT32UC3A0128-ALUR Atmel, AT32UC3A0128-ALUR Datasheet - Page 385

• Manufacturer Part Number: AT32UC3A0128-ALUR
• Description: MCU AVR32 128K FLASH 144LQFP
• Manufacturer: Atmel
• Series: AVR®32 UC3r

Specifications of AT32UC3A0128-ALUR

• Core Processor: AVR
• Core Size: 32-Bit
• Speed: 66MHz
• Connectivity: EBI/EMI, Ethernet, I²C, SPI, SSC, UART/USART, USB OTG
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 109
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 1.65 V ~ 1.95 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 144-LQFP
• Package: 144LQFP
• Device Core: AVR32
• Family Name: AT32
• Maximum Speed: 66 MHz
• Operating Supply Voltage: 1.8|3.3 V
• Data Bus Width: 32 Bit
• Number Of Programmable I/os: 69
• Interface Type: Ethernet/I2S/JTAG/SPI/TWI/USART
• Number Of Timers: 3
• For Use With: ATEVK1105 - KIT EVAL FOR AT32UC3A0ATAVRONEKIT - KIT AVR/AVR32 DEBUGGER/PROGRMMR770-1008 - ISP 4PORT ATMEL AVR32 MCU SPIATEVK1100 - KIT DEV/EVAL FOR AVR32 AT32UC3A
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

27.6.5.2
32058J–AVR32–04/11
Early Read Wait State
In some cases, the SMC inserts a wait state cycle between a write access and a read access to
allow time for the write cycle to end before the subsequent read cycle begins. This wait state is
not generated in addition to a chip select wait state. The early read cycle thus only occurs
between a write and read access to the same memory device (same chip select).
• An early read wait state is automatically inserted if at least one of the following conditions is
• if the write controlling signal has no hold time and the read controlling signal has no setup time
• in NCS write controlled mode (WRITE_MODE = 0), if there is no hold timing on the NCS signal
• in NWE controlled mode (WRITE_MODE = 1) and if there is no hold timing (NWE_HOLD = 0),
Figure 27-18. Early Read Wait State: Write with No Hold Followed by Read with No Setup.
valid:
(Figure
and the NCS_RD_SETUP parameter is set to 0, regardless of the read mode
The write operation must end with a NCS rising edge. Without an Early Read Wait State, the
write operation could not complete properly.
the feedback of the write control signal is used to control address, data, chip select and byte
select lines. If the external write control signal is not inactivated as expected due to load
capacitances, an Early Read Wait State is inserted and address, data and control signals are
maintained one more cycle. See
NBS0, NBS1,
A0, A1
27-18).
CLK_SMC
A[25:2]
D[15:0]
NWE
NRD
Write cycle
Figure
No hold
27-20.
Early Read
Wait state
No setup
Read cycle
AT32UC3A
(Figure
27-19).
385