MC908QL4MDTER Freescale Semiconductor, MC908QL4MDTER Datasheet - Page 159

• Manufacturer Part Number: MC908QL4MDTER
• Description: IC MCU 8BIT 4K FLASH 16-TSSOP
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC908QL4MDTER

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: LIN (Local Interconnect Network)
• Peripherals: LVD, POR, PWM
• Number Of I /o: 13
• Program Memory Size: 4KB (4K x 8)
• Program Memory Type: FLASH
• Ram Size: 128 x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 6x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 16-TSSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

(CHKMOD), as well as signal the SLIC that the buffer is ready by writing a 1 to TXGO. TXGO will remain
set to 1 until the buffer is sent successfully or an error is encountered, signaling to the application code
that the buffer is in process of transmitting. In cases of 1–8 data bytes only being sent (standard LIN
request frames), the SLIC automatically calculates and transmits the checksum byte at the end of the
message frame. The user can exit the ISR after SLCDLC has been written and the SLCF flag has been
cleared.
Freescale Semiconductor
Note 1. When writing TXGO bit only, ensure that CHKMOD and data length values are not accidentally modified.
PROCESS ERROR CODE:
BYTE FRAMING ERROR
CHECKSUM-ERROR
RETURN TO IDLE
BIT-ERROR
EXIT ISR
Figure 14-17. Handling Request LIN Message Frames
1. CLEAR SLCF
2. LOAD DATA INTO MESSAGE BUFFER
3. WRITE SLCDLC FOR THIS ID
Y
1n00 0xxx
(TXGO = 1)
(CHKMOD = n)
TRANSMIT COMPLETE
REQUEST MESSAGE
EXTENDED FRAME
ERROR CODE
READ SLCSV
CLEAR SLCF
INTERRUPT
PROCESS
EXIT ISR
N
N
?
?
MC68HC908QL4 Data Sheet, Rev. 8
1. LOAD LAST (£8) BYTES TO TRANSMIT
2. WRITE TXGO BIT TO START TRANSMIT
Y
DECREMENT SW BYTE COUNT BY 8
2. INITIALIZE SW BYTE COUNT
3. LOAD FIRST 8 DATA BYTES
4. WRITE SLCDLC FOR THIS ID
1. CLEAR SLCF
1nxx xxxx
(TXGO = 1)
(CHKMOD = n)
(SW BYTE COUNT £8)
ERROR CODE
READ SLCSV
CLEAR SLCF
LAST FRAME
INTERRUPT
EXIT ISR
N
Y
?
?
(1)
1. LOAD NEXT 8 BYTES TO TRANSMIT
2. WRITE TXGO BIT TO START TRANSMIT
N
Initialization/Application Information
Y
PROCESS ERROR CODE:
BYTE FRAMING ERROR
RETURN TO IDLE
BIT-ERROR
EXIT ISR
(1)
159