AT90LS2343-1SI Atmel, AT90LS2343-1SI Datasheet - Page 5
![IC MCU 2K FLASH 1MHZ IND 8-SOIC](/photos/6/50/65032/453-8-soic_sml.jpg)
AT90LS2343-1SI
Manufacturer Part Number
AT90LS2343-1SI
Description
IC MCU 2K FLASH 1MHZ IND 8-SOIC
Manufacturer
Atmel
Series
AVR® 90LSr
Specifications of AT90LS2343-1SI
Core Processor
AVR
Core Size
8-Bit
Speed
1MHz
Connectivity
SPI
Peripherals
Brown-out Detect/Reset, POR, WDT
Number Of I /o
5
Program Memory Size
2KB (1K x 16)
Program Memory Type
FLASH
Eeprom Size
128 x 8
Ram Size
128 x 8
Voltage - Supply (vcc/vdd)
2.7 V ~ 6 V
Oscillator Type
Internal
Operating Temperature
-40°C ~ 85°C
Package / Case
8-SOIC (5.3mm Width), 8-SOP, 8-SOEIAJ
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Data Converters
-
Pin Descriptions
AT90S/LS2343
VCC
GND
Port B (PB4..PB0)
RESET
CLOCK
Clock Options
Crystal Oscillator
External Clock
1004D–09/01
Supply voltage pin.
Ground pin.
Port B is a 5-bit bi-directional I/O port with internal pull-up resistors. The Port B output
buffers can sink 20 mA. As inputs, Port B pins that are externally pulled low, will source
current if the pull-up resistors are activated.
Port B also serves the functions of various special features.
Port pins can provide internal pull-up resistors (selected for each bit). The Port B pins
are tri-stated when a reset condition becomes active.
Reset input. An external reset is generated by a low level on the RESET pin. Reset
pulses longer than 50 ns will generate a reset, even if the clock is not running. Shorter
pulses are not guaranteed to generate a reset.
Clock signal input in external clock mode.
The AT90S/LS2323 contains an inverting amplifier that can be configured for use as an
On-chip oscillator, as shown in Figure 3. XTAL1 and XTAL2 are input and output
respectively. Either a quartz crystal or a ceramic resonator may be used. It is recom-
mended that the AT90S/LS2343 be used if an external clock source is used, since this
gives an extra I/O pin.
Figure 3. Oscillator Connection
The AT90S/LS2343 can be clocked by an external clock signal, as shown in Figure 4, or
by the On-chip RC oscillator. This RC oscillator runs at a nominal frequency of 1 MHz
(V
the clock source when programmed (“0”). The AT90S/LS2343 is shipped with this bit
programmed. The AT90S/LS2343 is recommended if an external clock source is used,
because this gives an extra I/O pin.
The AT90S/LS2323 can be clocked by an external clock as well, as shown in Figure 4.
No fuse bit selects the clock source for AT90S/LS2323.
CC
= 5V). A fuse bit (RCEN) in the Flash memory selects the On-chip RC oscillator as
AT90S/LS2323/2343
5